CA NO GE SOUTH AMB 18 2025 2026 PERIODICAL SERVICES FOR CERTAIN MARRIED AND OTM ACCN OF SARDAR PATEL ROAD IN B 2 SECTOR MAHESH NAGAR AND ADJOINING AREA OF AGE AGE B R II SOUTH UNDER GE SOUTH AMBALA CANTT

Amount

Taking down cement plaster of any description and in any position including raking out for keys, scrubbing down with water etc of any thikness & brick or stone wall etc. cement or cement lime plaster any description complete all as specified and directed.

Material and labour for 15mm thick rendering in cement mortar (1:6) on surface of any description of brick or concrete surface of wall and finished the surface even and smooth without using extra cement complete all as specified and as directed.

Material and labour for 15mm thick rendering in cement mortar (1:4) on surface of any description of brick or concrete surface of wall and finished the surface even and fair without using extra cement complete all as specified and as directed.

Material and labour for rough cast plaster with and including 15mm thick rendering in CM 1:3 on brick wall or concrete surface as specified in clause 14.22 of SSR Part-I complete all as specified and directed. Note:-(i) After applying the under coat of cement and sand mortar 1:3 not less than 10 mm thick and while it is still in plastic state the rough cast mixture consisting of crushed stone or fine gravel aggregate (which is generally of size between 6 to 12 mm depending on the texture required) mixed with coarse sand and cement in the ratio of 1: 1: 1 shall be applied and finished even. (ii) The mix of cement and sand shall be made slightly loose/wetter than normal for rendering to ensure that larger aggregates are thoroughly covered. (iii) Contractor's quoted rate shall include all above provisions and no extra shall be admissible on this account.

Material and labour for preparation of exposed brick wall surface by cleaning the surface wire brush to remove all dirt/loose materials from the bricks and from the joints between the bricks. Prepared surface should be then washed with diluted HCL acid (dilution ratio of 1:50) for three times in a day for two days. After acid wash surface should be allowed to be air dried for one day. NOTE : - Further treatment over the surface so achieved will be carried out only after approved of the same by GE.

Material and labour for 10mm thick cement plaster in CM (1:3) to ceiling surface and finished the surface even and smooth without using extra cement with and including applying three coats of white wash on ceiling complete all specified and directed.

Material and labour for preparation of new plastered surfaces of walls and applying two coats of oil bound distemper with hand roller, over a coat of alkaline resistant primer over a coat of wall care putty not less than 1mm thick as per manufacturer's instruction complete all as specified and directed.

Material and labour for preparation of new plastered surfaces of wall and applying two coats of cement base paint over a coat of primer on walls complete all as specified and directed.

Material and labour for preparation of new plastered surfaces of walls and applying two coats of exterior emulsion paint with hand roller, over a coat of primer complete all as specified and directed.

Material and labour for complete removal of existing treatment on surface of walls by using appropriate technique as approved by Engineer-in-Charge for complete removal of all layers of treatment and reaching upto old plastered surface and applying a coat of wall care putty not less than 1mm thick as per manufacture instructions and applying two coats of oil emulsion paint over a coat of alkaline resistant primer complete all as specified and directed.

Material and labour for preparing old painted surfaces of walls plastered/unplatered by washing, rubbing down and stopping of distempered and painted surfaces and applying one coat of oil bound distamper complete all as specified and directed.

Material and labour for complete removal of existing treatment on surfaces of walls, chajjas, fascias etc and effloroscent salts and treating oil and greasy spots washing down with water and applying two coats of cement base paint over a coat of alkaline resistant primer including filling up all cracks with tar plastic (STP) crack filler and also, make good to plastered surface complete all as specified and directed.

Material and labour for preparing old painted surfaces of walls, chajjas, fascias etc plastered/unplatered by washing, rubbing down and stopping of distempered and painted surfaces and applying one coat of cement base paint including filling up all cracks with tar plastic (STP) crack filler and also, make good to plastered surface complete all as specified and directed.

Material and labour for complete removal of existing treatment on surface of walls, chajjas etc effloroscent salts and treating oil and greasy spots washing down with water and applying two coats of exterior emulsion paint over a coat of alkaline resistant primer including necessary scaffolding etc complete all as specified and directed.

Material and labour for one coat of exterior emulsion paint including preperation of old decorated surfaces of wall chajjas balcony / pillars facias etc complete all as specified and directed.

Material and labour for preperation of old decorated brick/concrete, plastered or unplastered surfaces of walls, pillars cornices etc and applying one coat of white wash complete all as specified and directed.

Material and labour for preperation of old decorated brick/concrete, plastered or unplastered surfaces of ceilings etc and applying one coat of white wash complete all as specified and directed.

Material and labour for preperation of old decorated brick/concrete, plastered or unplastered surfaces of ceiling by brooming down with steel wire brushing,scraping down smoke soot , moulds, moss and effloroscent salts, trading oil and greasy spots etc. and applying one coat of oil emulsion paint on ceiling complete all as specified and directed.

Material and labour for preparation of old wood and wooden based surfaces of any description not otherwise described over 10 cm in width or girth and applying one coat of synthetic enamel complete all as specified and directed.

Material and labour for preparing old painted steel surfaces of any description not otherwise described over 10 cm width or girth and applying one coat of synthetic enamel paint complete all as specified and directed.

Material and labour for writing letters or figures (Block, Roman, Italic or Indian) on plastered surfaces with using black synthetic enamel paint on back ground and letter & numbers written with white synthetic enamel paint of 100mm height etc complete all as specified and directed.

Cleaning and removing all scale and dirt, etc from existing water storage tanks of capacity exceeding 250 litres and not exceeding 500 litres by emptying, drying and cleaning the tank by scrubbing the dust with wire brush from tank including cleaning from mouths of circulating pipes, to entire satisfaction of Engineer-in–charge of cleaning , including writing date of cleaning with oil paint of of visible colour in font size not less than 100 mm, complete all as specified and directed (The rates includes for disconnecting of existing water tank, lowering if required and hoisting, reconnecting and refixing in same position after cleaning ) NOTE: - (i) The whole process of disconnecting, reconnecting and refixing in same position after cleaning shall be done on the same day, if failing so, Rs. 100/- shall be deducted for each tank per day from the contractor due. (ii) A separate register to be maintained by contractor for cleaning and occupant signature with date to be obtained in it.

Cleaning and removing all scale and dirt, etc from existing water storage tanks of capacity exceeding 500 litres and not exceeding 1000 litres by emptying, drying and cleaning the tank by scrubbing the dust with wire brush from tank including cleaning from mouths of circulating pipes, to entire satisfaction of Engineer-in–charge of cleaning, including writing date of cleaning with oil paint of visible colour in font size not less than 100 mm, complete all as specified and directed (The rates includes for disconnecting of existing water tank, lowering if required and hoisting, reconnecting and refixing in same position after cleaning ) NOTE: - (i) The whole process of disconnecting, reconnecting and refixing in same position after cleaning shall be done on the same day, if failing so, Rs. 100/- shall be deducted for each tank per day from the contractor due. (ii) A separate register to be maintained by contractor for cleaning and occupant signature with date to be obtained in it.

Material and labour for 5mm thick PVC hollow interlocking wall panelling of width 250mm for wall paneling for fixing on to wall with screws and solvent alongwith corner and u channel beading of colour choice including dismantling old boarding/panelling all as specified and directed. sting ceiling any type including wooden filletes if any complete all as specified and as directed. Note : Rate will be inclusive any elctrical board, fitting etc effected for removing & refixing and mating good to match with existing complete all as specified and as directed

Material and labour for ready mix plaster of average thickness 15mm on brick work or concrete surfaces finished even and smooth including necessary scaffolding complete as per manufacture's instruction and as directed by Engineer-in-Charge.

Material and labour for one coat of oil bound distemper on ceiling of old decorated plastered or unplastered surfaces of ceiling etc, complete all as specified and directed by Engr-in-Charge.

Material and labour for two coat of oil bound distemper of old decorated plastered or unplastered surfaces of walls, balcony, etc by brooming down or steel wire brusing scraping down smoke soot, moulds, moss and effloroscent salts, trading oil and greasy spots etc over a coat of alkaline resistant primer over a coat of birla white putty, complete all as specified and directed by Engineer-in-Charge.

Material and labour for for complete removal of old existing treatment of wall (external/internal) and ceiling finishes using mechanical dry wall sander machine (having mechnical vaccum mechanism) having RPM not less than 1500, sanding pad of 80 grit and above having dia of 7"/9" to completely remove the existing treatment of wall and ceiling surface and ready to take new surface finishes complete all as specified and directed by Engineer-in-Charge.

Providing technically qualified person (Engineer) for preparation of PSMB including carrying out of measurement of old Bldgs as per normal Engineer practice falling under the area of AGE B&R-II under GE (South) Ambala Cantt. Also providing necessary documents (e.g stationery items etc.) for preparation of PSMB, entering site measurement of following items in PSMB as per the format kept in Sub Division: - (a) White wash in ceiling surfaces. (b) White wash in wall surfaces. (c) OBD on wall surfaces / dry distemper (d) Interior emulsion (Plastic paint) on wall surfaces. (e) Cement base paint on wall surfaces. (f) Exterior emulsion paint on wall surfaces. (g) Synthetic enamel paint on wooden surfaces. (h) Synthetic enamel paint on steel surfaces. (j) Varnish. (k) Small article paint steel/wooden. This item includes submission of PSMB building wise falling under AOR of AGE B&R-II under GE (South) Ambala duly scrutinized and signed by JE (Civil) and Engineer-in-Charge and Numbered and audited by Audit authorities. NOTES: - 1. The above PSMB shall be prepared by Engineer having minimum qualification diploma in Civil Engineering from approved Technical Institute alongwith minimum work experience of three years. Details of qualification and experience shall be verified and kept on record by Engineer-in-Charge. 2. PSMB shall be submitted by the contractor before submission of 1st RAR of above work complete in all respect duly signed and audited. 3. The contractor shall be paid for Square meter of periodical items worked out in PSMB as per plinth area of particular bldg. 4. Necessary security pass shall be issued by Engineer-in-Charge in favour of Engineer being appointed by the contractor for the purpose on the basis of particular submitted by the contractor in writing alongwith Police Verification with regard to Character and antecedents of the Engineer. 5. Irrespective of above, in few bldg where complete periodical services are not carried out (Only 2 or 3 items are executed) contractor will prepare PSMB for entire bldg covering all items as mentioned above irrespective of item executed by him as per direction of Engineer-in-Charge. 6. In case of repetitive nature of bldgs where work has been executed by the contractor the payment shall be made only for area to be measured at first instant. No repetition of area shall be allowed and taken into consideration for payment purposes.

NOTE:- Amount of credit of Rs. 12000.00 for retrieved materials is mentioned in Schedule of Credit Page No 19 of tender documents in pdf form which will be deducted offline while acceptance of tender.

Puneet Sharma (BID ID -3340410)

Shubham Enterprises (BID ID -3333783)

Anil jindal and sons (BID ID -3336613)

Swastik Builders (BID ID -3331403)