RRD LWSS Deoth Vao Humbar IC

Excavation in foundation & trenches etc. in earth work including all kinds of soil such as pick work Jumper work, blasting soft and hard rock conglomirate up to all leads and lifts stacked the excavated soil not more than 3mtrs. clear from the edge of excavation and then returning the stacked soil in trenches consolidating each deposited layer by ramming and watering and then desposing of all surplus excavated earth as directed by the Engineer-in-Charge.

Excavaton including bailing or pumping out water during excavation in foundation and trenches etc. in earth work in all kind of soil within all leads and lifts and to the entire satisfaction of the Engineer-in-charge.

Providing and laying cement concrete 1:3:6 (1cement: 3sand: 6 graded stone agg. 20mm nominal size) and curing complete excluding the cost of form work in foundationand plinth and to the enitre satisfaction of the Engineer-in-charge.

Providing and laying cement concrete 1:1.5:3 (1cement: 1.5 sand:3 graded stone aggregate 20mm nominal size) and curing complete excluding the cost of form work and reinforcement for reinforced concrete work in:-

Foundation footings base of columns and the like and mass concrete and to the entire satisfaction of the Engineer-in-charge.

Wall any thickness but not less than 0.1mtr thickness attached pilasters, buttresses, plinth and string courses etc. from top of foundation level up to floor two level and to the entire satisfaction of the Engineer-in-charge

Suspended floor roofs landing shelves and their supports balconies, beams girders bressumers and cantilevers up to floor two level.

Providing and laying No fine concrete 1:4 (1cement: 4sand) aggregate stone 40mm nominal size) and curing complete: in allw (any thikness, but not less than 0.1mtr thickness attached, pillaster, butresses, plinth and string courses etc. from top of foundation level upto floor two level and to the entire satisfaction of the Engineer-in-charge.

Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm so as to give a fair finish including centering shuttering, strutting and propping etc. with wooden battens and ballies, height of propping and centering below supporting floor two ceiling not exceeding 4 mtr and removal of the same for in-situ reinforced concrete and plain concrete working:-

Vertical surfaces such as walls (any thickness) partitions and the like including attached pilasters buttresses, plinth and string courses and the like and to the entire satisfaction of the Engineer-in-charge.