Repairing work of Existing cattle pond at kumbharvada nari and akhilesh circle, Bhavnagar

Excavation for foundation upto 1.5 m depth in

any type of soil including sorting out and

stacking of useful materials and disposing off

the excavated stuff upto any lead.

supply 0.80 mm thick corrugated G.I sheet

with 10 cm side lap , 15 cm verticle lap with

mm dia G.I J - bolt , ai bolt and galvanised

and bitumen washer with fitting

Steel work, welded in built up sections framed

work including cutting, hoisting, fixing in

position and applying a priming coat of red

lead paint(CORROSION RESISTANT

YELLOW BASE) and two coat of oil paint as

suggested. (A)In beams and joists, channels

angles Tees, flats, with connecting lates or

angle cleats as in main and cross beams. Hip

and jack rafters, purlins conneted to common

rafters and the like

4 Unskilled Labour 45.00 487.00 per Day

Boring holes 3.5 m deep in ordinary soil (for

cast in situ piles) and getting out the soil and

disposal of the surplus excavated soil as

directed within any lead as required dia or as

per instruction of engineer incharge for 100 to

Providing and laying controlled cement

concrete M.25(1:1:2) exposed work with

curing etc. complete including the cost of

formwork but excluding the cost of

reinforcement for R.C.C. work USING

APPROPRIATE CHEMICAL as per IS

nominal mix concrete for any height of

concrete work FOR ANY COMPONENT OF

BUILDING AND COMPOUND WALL 1:3:6 (1- cum

7 Providing and laying cement concrete

Providing laying Controled Reinforced cement

concrete M 30 including curing complete

excluding the cost of form work and

reinforcement for reinforced concrete work in

concrete road Coarse and fine aggregate

confirming to IS:383 maximum size of coarse

aggregate not exceeding 25 mm, using

mechanical weigh batcher, mixed as per

approved mix design, laid, placed & distributed

with sufficient man power using M.S. Side Rail

of road thickness with necessary nut bolt

plates, fixing as per width, compacted with

Poker vibrator V.D. system ( Trimix ) &

Surface Plate Vibrator, Troweling to be carried

out with the same machine running on

troweling blades, finished in a continuous

operation including provision of contraction,

expansion, construction and longitudinal

joints, joint filler separation membrane, sealant

primer, joint sealant debonding strip, dowel

bar, tie rod, Surface Hardner must be spraied

on final concrete surface to harden the top

surface, admixtures as approved, curing

compound, finishing to lines and grades

Supplying, bending, binding and placing of

TMT FE 500 or 500D as per bmc vendor list

Brick work using common burnt clay building

bricks having crushing strength not less than

35 kg./Sq.Cm. in foundation and plinth in

Cement Mortar 1:5. (1- Cement : 5 -fine sand)(

Finishing wall with weather proof exterior

plastic emulsion paint on wall surface (two

coats) after one coat of primer to give an

required shape even shade after thoroughly

brushing the surface to remove all dirt, and

10 remains of loose powdered materials.etc 702.00 140.00 SQM

complete The material shall be as described in

list of approved material.shade and pattern as

directed by Engineer in charge / Executive

Engineer in charge.paint should be comparae

to asian paint apex quality.

Providing 20 mm thick double coat cement

plasteron interior brick / concrete work for

comprising of base coat of 12 mm thick

11 cement plaster incement mortar (1 Cement : 4 702.00 258.00 SQM

coarse sand) in rough finishing and 8 mm

thick top coat of cement mortar 1:2 (1 Cement

: 2 Coarse sand) finished with trovel including

scaffolding curing etc. complete.

12 dismentling of concrete work 42.00 600.00 cum

pvc plumbing pipe with consil and all type of

material including T -bend,nipple, elbow etc

and required fitting complete work inside or

outside wall as per site condition.

i15 mm internal dia 140.00 213.00 RMT

ii20 mm internal dia 60.00 254.00 RMT

iii25 mm internal dia 70.00 292.00 RMT

HANDLE VALVE of cast iron/brass of

14 approved brand selected by engineer

i incharge/ executive

15 mm internal dia engineer/city engineer

ii20 mm internal dia

iii25 mm internal dia

job work for construction of open drain in

TRIMIX AREA throught out campus for

sufficient waste water discharge velocity with

appropriate plaster, bed concrete, excavation,

levelling and all other miscallanious item

excluding top jali but including all civil work as

decided on site by engineer incharge/

executive engineer/city engineer

Vitrified tiles of grade a with 1:8 cement sand

bed of 40 to 50 mm thick and cement slurry for

fitting with joint filling for flooring as per

instruction given by EIC.

water tank fitting - as per instruction supply

1000 ltr capacity water tank having three

protection layer with all inlet, outlet and over

flow pipe fitting complete work

pvc plumbing pipe with consil and all type of

material including T -bend,nipple, elbow etc

18 and required fitting complete work inside or 15.00 254.00 RMT

outside wall as per site condition 20 mm size

inside dia pipe

19 chicken mesh supply for jointing 10.00 106.00 SQM

20 water connection with necessory fitting Page 3 of 5 1.00 1161.00 job

21 drainage connection with necessory fitting 1.00 1393.00 job

poweder coated aluminium section supply for

Point wiring for Light / Bell with 2-1.5 sq.mm

& earthwire of 1.5 sq.mm (Green) both are of

ISI marked 1.1 KV grade FRLS PVC insulated

multistrand copper wires, in following type of

pipe to be erected concealed in/ on surface on

wall/ceiling complete with 6A Modular type

switch / bell push & accessories and earth

23 continuity of following type, erected on PVC / 4.00 470.00 pt

Metallic box, single mounting base frame

covered with textured/metallic front plate

modules erected on / in wall / ceiling as per

pipe erected, with necessary Lamp

holder/ceiling rose / H.D.Connector as

directed.(a) with medium class Rigid PVC pipe

and accessories Cat. III

Point wiring for FAN with 2-1.5 sq.mm &

earthwire of 1.5 sq.mm (Green) both are of

.ISI marked 1.1 KV Grade FRLS PVC

insulated multistrand copper wires, in following

type of pipe to be erected concealed in /

flushed on wall/ceiling complete with 6A

Modular type switch and hum free EME four or

more step type electronic fan regulator with

separately mounted and accessories with

earth continuity of following type erected on

PVC / Metallic box, single mounting base

frame covered with textured/metallic front

plate modules erected on / in wall / ceiling as

per pipe erected. with necessary ceiling rose /

H.D.Connector as directed.(a) with medium

class Rigid PVC pipe and accessoriesCat. III

Point wiring for Individual Plug with &

earthwire of 1.5 sq.mm (Green) both are of ISI

marked 1.1 KV grade FRLS PVC insulated

multistrand copper wires, in following type of

to be erected concealed in / on surface of wall

/ ceiling complete with Modular type switch &

25 pin Plug erected on PVC / Metallic box 6.00 290.00 pt

covered with appropriate front plate modules

erected on / in wall / ceiling as per pipe

erected with following type of accessories.[I]

For 6A Plug with 2-1.5 sq.mm Cu. Wire(a) with

medium class Rigid PVC pipe and

accessoriesCat. III

Mains with 1.1 KV grade FRLS PVC insulated

ISI marked stranded Copper conductor wire in

following type of pipe to be erected concealed

in /flushed on wall/ceiling, with 1.5 sq. mm

26 copper conductor FRLS PVC insulated 50.00 90.90 rmt

stranded wire of green colour for earth

continuity of following size (a) with medium

class Rigid PVC pipe and accessories(b)

wire 2.5 sq. mm

Miniature circuit breaker single pole 6A to 32A

suitable to operate on 240 V A.C. system and

27 having breaking capacity 10 KA to be erected 1.00 1161.00 Each

in existing box. confirming to IS 8828/1996

with ISI Mark Cat.III

Supplying and erecting LED indoor fittings with

LEDs of wattage 0.2 Watt to 0.5 Watt

Providing & erecting Approved make Power

Saving 50 Watt Ceiling Fan with double ball

bearing ISI mark with Condenser 230 volt A.C.

50 Hz 1200 mm sweep complete having

3blades with aluminium blades with , canopy &

30 cms. down rod erected with 24/ 0.2, 3 core

flexible wire with earthing.(Make shall be

approved by Engineer in charge))

Approved make ELCBs / RCCBs conforming

to IS: 12640 and having sensitivity of 30 mA

and Short Circuit withstand capacity of 6 KA

and suitable for operation on 3 phase and

30 neutral 415V. having characteristic of quick 1.00 3500.00 Each

action & tripping with all advance feature & do

not incorporate any electronic component for

following Max. rating erected as directed.(iii)

63 Amps. FP Cat. III