Supply of SS Dinning tables and Plastic moulded chairs without arms to S.V. School for Deaf and Dumb and S.V. Junior college for Deaf, Tirupati"

Supply of Stainless steel dining tables (4 Seater) of overall size 2400 x 500 x 750 mm (including nylon bush) of top sheet provided with SS 1.50 mm thick double folded alround moundted on SS angular frame of size 32 x 32x3 mm and additional three supports at top in width wise with SS angle of size 32 x32 x 3 mm and one length wise middle support with SS flat of size 25 x 5 mm. The SS legs with OD 38 mm dia pipe of 1.5 mm thick of 6 Nos with adjustable nylon bullet feet are to be provided. At inside corner of the top frame near the leg portion, 40 x 40 x 3 mm SS triangle sheets are to be provided for full welding of legs. Additional inclined supports are to be provided at top of the legs to the top frame to provided additional strength for the legs. The support pieces are to be welded to the angle frame and top sheet at mid spans of the table. The cross supports (3 Nos) are to be provided in width wise SS pipes of OD 25 mm dia of 1.5 mm thick and in length wise two central supports at bottom level at 150 mm height. SS dining table weight should be 43 kgs +/- 2 kgs.

Note: Supply and fixing of Stainless steel SS 304 Grade tubes, sections, plates, sheets and pipes of all sizes and diameters etc., including cost and conveyance of all materials and labour charges for fabrication of stainless steel works using SS welding rods including buffing, polishing, lacquer finishing, to present seamless finishing etc., complete as directed during execution. The following equipment to be fabricate with argon welding with machine rolled and plasma cutting with smooth finish. The items are fabricated with stainless steel of 304 grade and the testing for confirmation of SS AISI 304 grade should be tested at site and submitted that same to the department by the contractor at his own cost. The tolerance allowance of (+/-) 10 mm is allowed for measurements for fabrication. The rate is including cost and conveyance to site of work, incidental charges and including cost of nylon bushes. The rate is excluding GST

Supply of Co-polymer poly -propylene plastic moulded chairs without arms of confirming to IS : 13713-1993 specification and not less than the following physical parameters. (a) Seat height from floor level measured at centre not less 440 mm. (b) Seat width and depth at middle place are 410 mm & 380 mm and above respectively. (c) Back rest width and height 490 mm and height 460 mm respectively. (d) Total weight of plastic chair: 2.20 kg. The rate is Excluding GST. Note: The material should be in Virgin Quality. Brands: National / Nilkamal / Supreme