FACE LIFTING OF SHOPING COMPLEX AREA IN COAST GUARD COMPLEX AND ADDITION ALTERATION TO COMPOUND WALL INFRONT OF MAIN GATE IN COAST GUARD COMPLEX MALKAPURAM VISAKHAPATNAM UNDER AGE I CG VISAKHAPATNAM

Amount

Excavation in post holes or similar holes n.exc 0.5 cum each in soft / loose soil , getting out returning filling in and ramming with earth or broken rubble around in layers not exc 25 cm, watering etc. and removing surplus soil to 50 m distance and making good surface complete all as specified and as directed.

M& L Cement concrete 1:2:4 Type B 2 (using 40 mm graded aggregate ,in foundations, filling and mass concrete complete all as specified and as directed.

M & L for Steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to IS 1161 1979 grade ST-240 complete all as specified and as directed.

S&F Framed work as in doors / gates or other frame work with angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering, etc. to be prepared for hanging or sliding with and including either hooks (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening confirming to Fe-410-w or E -250 quality A.. complete all as specified and directed.

S& F Pre-painted galvalume aluminum zinc coating trapizoidal profile sheet of 0.50 mm thick [TCT] of any having tensile strength of 550 Mpa as in roof covering / cladding to wall, fixed with self tapping screws complete all as specified and as directed. Make: M/s TATA BLUE SCOPE, M/s LLOYD INSULATIONS INDIA LTD, M/s BUILD TECH / M/s. Jindal

S&F 10 mm thick Solar Control Polycarbonate sheet (Multiwall) with required color such as blue, brown or green and of required brand as approved by Enginner in charge of required shape fixed with EPDM rubber gasket both side and top and joints filled with silicon solvent to make the joint water proof. Polycarbonate sheet and profile shall be fixed with self taping and drilling 50 mm long steel screws fixed not more then 150 mm c/c complete all as specified and as directed. The rate quoted by the contractor shall be inclusive of cost of all materials and labour for cutting, bending and fixing of polycarbonate sheet, Alocx, EPDM gasket,self taping,nuts & bolts etc.

S & F Plain, galvanised, mild steel sheeting, in ridges, hips, valley gutters, drip and straight flashings (length and girth as fixed) with grade of zinc coating 275 with L-type or J-type or cranked hook bolts with roof sheeting in roofing complete all as specified and as directed.

S&F 110 mm bore PVC (SWR) Soil, waste and vent pipes single socketed in any length with rubber ring joints fixed to walls complete all as specified and as directed.

S&F 110mm bore PVC (SWR) bends of any radius with access door complete all as specified and as directed.

M&L for preparation of new steel surfaces of any description over 10 cm width or girth, not otherwise described and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and as directed.

Taking down cement plaster of any description on brick or stone walls or concrete surfaces etc. including raking out joints hacking for key, scrubbing down with water etc. complete all as specified and as directed.

M&L for rendering 15 mm thick in cement mortar 1:4 on fair faces of brick work or concrete surfaces, finished even and smooth without using extra cement including mixing with liquid WPC all as per the manufacturer's instructions complete all as specified and as directed. (Note :- WPC will be measured and paid separately)

Supply only Integral water proofing compound

M&L for rendering 15 mm thick in cement mortar 1:6 on surface other than fair face of brickwork finished even and smooth without using extra cement complete all as specified and as directed.

M&L for rendering 5 mm thick in cement mortar 1:3 on ceiling of brick or concrete surface, finished even and smooth without using extra cement complete all as specified and as directed.

M&L for preparation of new / old plastered or unplastered surfaces of ceiling and applying three coats of white wash complete all as specified and as directed.

M&L for preparing the new/old plastered surfaces and applying two coats of oil bound distemper over a coat of primer on walls complete all as specified and as directed.

M & L for preparing old plastered / newly plastered surfaces of walls and applying two coats of Weather Proof Exterior Acrylic Emulsion paint of approved make and shade over a coat of approved primer as recommended by the manufacturer on surfaces of walls complete all as specified and as directed . Make : Apex from Asian Paints / All Guard from Berger / Weather Shield Max Exterior Acrylic from ICI Dulux

M & L for applying two coats of cement based wall care putty on walls/ ceilings to obtain a smooth surface including making good any undulations on the surfaces complete all as specified and as directed. Make for Putty : JK white cement / Birla wall care / Jenson & Nicholson

S & F 12 mm thick toughened & frosted glass with etching and frosting as per design for glass partition/door fixed with necessary screws, sealent , stainless steel patch, and all fittings etc. complete with all stainless steel builders hardware used as per site requirement and complte all as specified and directed by Engineer-in-Charge. Note :- Unit rate quoted to be deemed to include for cost of all material & labour and no other item shall be measured and paid separately.

S & F double action floor spring hydraulically regulated made up of minimum 1.25 mm thick aluminium alloy sheet foundation box, main body with stainless steel cover, governing pivot made of brass, other parts made of mild steel heavy duty and fixed complete all as specified and as directed.

S&F salon wash basin of size 530 x 610 mm with head rest and chair, tiltable stand, hand shower, hot & cold mixer and waste coupling with strainer, waste pipe, PVC connection, stop valve etc. complete with all necessary fittings as per site requirement and all as directed by Engineer-in-Charge. Make :- Cera Cat Part No. S2020110 or its equivalent in Parryware or as approved by AGE(I).

S & F aluminium composite panel cladding with Acrylic Letter LED Signage on column, ceiling, facia and wall ACP 1-VL-12 light blue of make Alstone/Durabuild of approved colour shade and pattern to be provided on exposed external surfaces with and including all necessary aluminium frame work complete as directed. The panel shall consist of 3 mm thermoplastic core of antitoxic LDPE sandwiched between 2 skins of 0.5 mm thick aluminium sheet making a total panel thickness of 4 mm with outer surfaces finished with PVDF based coating 30 micron, inner surfaces finished with a thin coat of polyester paint fixed on aluminium panel of grid size shall be n.exc. 2 sqm and size of section shall be 38 mm x 50 mm and 1.5 mm thick and grid shall be fixed to wall by flat iron clamps 25 mm x 6 mm at the distance not more than 1.0 m center to center and fixed as as per manufacturer's instruction and colour/texture/pattern shall be approved by AGE (I). Note :- Acrylic letters will be fixed as per site requirement and directed by Engr-in-Charge. These letters will be measured and paid separately under respective item.

S & F fully retro Reflective Sign board with lighting effect of any size but not exceeding 4.5 Sqm each (Both side written) made out of 18 gauge CRCA sheet with 25 mm square pipe 1.60 mm thick sheet having entire surface of both sides fully bonded with retro reflective sheeting of HIP grade Tape having pressure sensitive adhesive boards and messages as indicated cut out back ground in blue/green and matter in white colour tape having two posts 3.0 m long made of 50 mm square pipe 1.6 mm thick sheet embeded in PCC 1:2:4 of block 300 mm x 300 mm x 600 mm depth including necessary earth work or fixed the board all as per site requirement and all as directed by Engr-in-Charge.

M & L for repairing of RCC chajja, roof projection, facies, RCC parapet wall and exposed reinforcement portion area of thickness of RCC n.exc 75 mm by applying one coat of cement slurry reinforced with welded mesh of weight exc. 2 kg per Sqm but n.exc 3 kg per Sqm & filling the cement concrete (1:2:4) type B0, 12.5 mm graded stone aggregate at damaged concrete surface and finish the surface with 5 mm thick cement sand mortar 1:3 complete all as specified and ad directed.

Removing the existing treatment from the roof, Roughening surfaces of old concrete floor or concrete surfaces by picking, sweeping clean and washing down with water to remove dust etc, M&L for brushing neat cement slurry with 3 Kg of cement per Sqm, M & L for 25 mm thick cement concrete (1:2:4) type B-1, using 20 mm graded stone aggregate , rendering 15 mm thick on fair faces of concrete surfaces in cement mortar 1:3 and finished even and smooth without using extra cement including mixing of water proofing compound @ 2% by weight of cement, provn of APP polymeric waterproofing membrane of 3 Kg / Sq.M incorporating a centre core of 90 micron thick HMHDPE film including coating the surface with a coat of water based bituminous Primer @ 100 gms / Sqm, followed by a coat of blown bitumen of grade 85 / 25 or 90 / 15 @ 1.2 Kg / Sq.M each at top and bottom of the membrane followed by a coat of bituminous aluminium paint @ 0.50 lit / sqm complete including sealing all joints by thermo fusion with minimum 10cm overlap and on vertical surface the membrane shall be inserted in grooves and packed in CM (1:3) all as per manufacturer's instructions on non accessible roofs complete all as specified and as directed. Make : M/s. HYPERPLAS IWL CHENNAI/ M/s. MULTIPLAS BY STP TEXES LIMITTED ,GOREGOAN/ M/s. STP SUPERIOR POLY PLUS BY STP LIMITED, KOLKATTA/ M/s. SHIVAM TAR PRODUCTS .

Excavation in trenches not exceeding 1.5 m deep and getting out in soft/loose soil complete all as specifed and as directed.

M&L for PCC lean concrete 1:4:8 Type D-2 (using 40 mm graded aggregate) as in foundations, filling and mass concrete complete all as specified and as directed.

Demolition of brick work or stone/ boulder masonry, built in cement mortar including all quoins, pillars etc. complete all as specified and as directed.

M&L for brick work with fly ash bricks, straight or curved on plan exc 6m mean radius in built in cement mortar 1:6 complete all as specified and as directed.

M&L 25 mm thick damp proof course to horizontal or vertical surfaces including necessary formwork in cement concrete 1:2:4 type B-0 complete all as specified and as directed.

M &L for Providing cement concrete 1:2:4 type B-1 (using 20 mm graded aggregate) in copings/benching and other similar works all as specified and directed.

M&L for 20 mm thick granite (of any type) tiles machine cut in skirting / dado laid over 15mm thick CM 1:4 and jointed with grey cement slurry and pointed with white cement with admixture of pigment to match the shade of granite stone including cutting and polishing complete all as specified and as directed.

Returning, filling soil including spreading, levelling watering and well ramming of soft/loose soil in layers not exc 25 cm thick complete all as specified and as directed.

Removing excavated soils to a distance not exc. 50 m and depositing where directed at a level not exc 1.5 m above the starting point complete all as specified and as directed.

S & F Stainless steel decorative fencing posts (304 grade) of any dia connected with suitable stainless steel chain of any description with hooks including embeding of posts in concrete with necessary securing bolts, screwing etc. complete all as specified and as directed. (Note :- Stainless steel chain will be measured and paid separately)

Supply only stainless steel chain ( SS - 316 grade)

S & F of stainless steel chromium plated letters or symbols of any description ( as per site requirement but size of each letter / symbol not exceeding 12 inch each ) made out from standard thick stainless steel sheet (not less than 1 mm thick ) superior quality fixed with screw on existing granite cladding including lighting effect complete all as specified and directed. Note :- Granite cladding work will be measured and paid separately.

Surface excavation in soft/loose soil n exc 30 cm deep and averaging 15 cm deep and getting out complete all as specified and as directed.

M&L for hard core of gauge n exc 63 mm, deposited, spread and levelled in layers n exc 15 cm thick, watered and rammed to a true surface complete all as specified and as directed.

M&L for 100 mm thick Cement concrete type D-2, 1:4:8 (using 40 mm graded granite stone aggregate) in sub base of flooring/ hard standing etc complete all as specified and as directed.

M & L for Sand filling under floors or in foundations including watering and consolidation complete all as specified and as directed.

M&L for 60 mm thick PCC M-35 machine pressed precast concrete glazed coloured interlocking pavor block of any shape and size confirming to IS-15658-2006 using with grey cement and pigment complete all as specified and as directed. Make : Ultra tiles Pvt. Ltd/Terra firma/Ecco Scope/ Mehtab tiles/ Bharat Tiles & Marble Pvt Ltd / National Tiles & Industries Pvt Ltd / Nitco Tiles Pvt Ltd / Nimco Tiles / Metro Tiles Bombay / Vitco Tiles Bombay / Anjali tiles

M&L PCC 1:3:6 type C1 (using 20 mm graded aggregate) in flooring etc. complete all as specified and as directed.

Forming contraction (dummy) joints 50 mm deep x 10 mm wide, filled with sealing compound of grade 'A' complete all as specified and as directed.

VIJAY VINAYAKA INFRA

K & K CONSTRUCTIONS

RAVITEJA ENGINEERING WORKS

SRI SRK ENGINEERS

VENKATA SHIVA RAJENDRA PRASAD ARAVALA

ALLURI CONSTRUCTIONS