Fabrication Tenders

Custom Bid for Services - FABRICATION AND INSTALLATION OF ALUMINIUMISED PARTITION BOARD PRE LAMINATED Similar Category Repair, Maintenance, and Installation of Plant Systems/Equipments (Version 2)

Custom Bid for Services - FABRICATION AND INSTALLATION OF WOODEN DOORS ON EXISTING RACKS Similar Category Repair, Maintenance, and Installation of Plant Systems/Equipments (Version 2)

Repairing welding of both side LH and RH Main arm mounting bracket and blade support arm an cross arm, tilt cylinder mounting and tilt cylinder cover an brace arm and its mounting, both side boss sprocket oval hole, both side LH n RH cutting edge end

Fabrication Installation of Iron Notice Boards to Prevent Garbage Dumping at Various Garbage Vulnerable Points GVPs in H/West Ward.

Fabrication and Fitting of Fan Blade, Fan Cover and Terminal Box of 300 HP Motor at Dobari Colliery Under ABDKGC.

Fabrication of 04Nos Engine Guards and 4Nos Transmission Guards of 04Nos Motor Graders (MG25165, 25170, 25206, 25208) of Amlohri Project

ESTIMATE FOR OPERATION AND MAINTENANCE OF FLY ASH BRICK MANUFACTURING UNIT AT VILLAGE RAMGARH ON WRD LAND. (CIVIL/FABRICATION COMPONENT)

"Fabrication of Instrument Air Header & Branch Lines for Pneumatic Actuators installed at Fuel Oil Pump House (FOPH)" DSPMTPS, Korba(East).

Supply, Installation, Testing, Commissioning, and Training of 3D Printer for Fabrication of Microreactors and Microfluidic Devices with Accessories and Software

Designing, Engineering, Fabrication (with material), Supply, Erection and Commissioning of Telescopic Spout at Ash Silo under AHP-MM Department, STPS.

Fabrication supply and instalaltion of 6feet x 4feet entrance point with 12mm thick glass covered, Supply and installation of wide charcoal louvers including fixing with plywood support

Supply Fabrication and Erection of CS Structural platform and ladder to access EOT cranes of FRP Block 1 and 2 FFP RUP and Infrastructure area at FRFCF site Kalpakkam

For fabrication and erection of Iron shed 25 feet x 12 feet for EnM installations Pump switch Gears Etc. at Kankanee colliery. (B) and fabrication and erection of Iron shed 20 feet x 12 feet for 1.5 MVA 11 KVA/3.3 KV indoor type power transforme

Flush Butt welding of rail on various loop lines and other lines in the jurisdiction of ADEN/L/CNB under DEN/V/PRYJ

Fitment & welding of 'Lifting Pads' and 'Stiffener' in BTPN wagons through outsourcing as per RDSO Drawing Nos. WD-86081-S-54 (Alt-15).

Carbon dioxide Gas for welding specn NO.IS:307/1966. Grade-I and CO2 purity Minimum 99.98 / 99.9% volume (Fertiliser quality).OLD PL(81989120,81988813)

1.5 KW (1500W) 3-IN-1 LASER CLEANING, WELDING AND CUTTING MACHINE, REFERENCE MODEL - RAYTOOLS SLW-1500W OR EQUIVALENT MODEL OF THE MAKES VIRGO PLUS, SUPER WAVE (SUP) AND HARSLE, COMPLETE WITH 1500W FIBER LASER SOURCE, AUTOMATIC WIRE FEEDER, HANDHELD ... LASER WELDING TORCH/HEAD ... WITH WELDING , ...

Custom Bid for Services - Mechanical Piping and Handrailing Fabrication & Erection Works Similar Category Piping Erection Service Repair, Maintenance, and Installation of Plant Systems/Equipments (Version 2)

Fabrication and erection of sodium piping system for testing and performance evaluation of 350m3/hr ALIP in Sodium Technology Complex, FRTG, IGCAR.

Design, Fabrication, Printing, Supply and Installation of different types of instruction boards, signage board and allied items at ELS/TKD Shed

Dismantling, fabrication and erection of light structurals, pipelines, valves etc (outside of mill area) at Energy Mechanical in TNPL Unit-1

Design Supply Fabrication and Installation of Customized Vertical Storage System at the Vile Parle Office under AEMaint WW WS South division

Fabrication and Supply of wooden box for Solar MARS100 engine Sl ESN0375M for transportation of Engine to OEM workshop for overhauling

Custom Bid for Services - Structural Fabrication and Erection Work of Platform for Railway Track-2 Similar Category Repair and Overhauling Service

Design, Fabrication, Supply, Testing and Commissioning of Light Load Run Test facilities for 3 phase traction motors of WAG-9 locomotives.

Custom Bid for Services - Fabrication of 16 Nos of I Level Test Equipment of CVFDR for LCH Similar Category Calibration Services

Welding and renovation of drain from the house of Chitta Ghosh to Ramesh Tiwari at Nichupatty main road in ward no 6 under CMC

Reconditioning of tongue rails, removing burrs, welding of slide chairs, broken plates of points and crossings under jurisdiction of Senior Divisional Engineer (West) - Ahmedabad.

Outsourcing of welding & repair activities for unloadable wagons at varioussidings under jurisdiction of Kirodimalnagar station for a period of two yearson open tender basis.

NER-LJN Division:- GKP-LJN section:- Flash Butt Welding of 20 rail panels/ Free Rails/ 2 Rail panels/ 3 Rail panels of all rail sections (New/SH) at site (in situ/Cess) using contractor's own Mobile Flash Butt Welding plant. (Against sanctioned work of LWP-2025-26 in jurisdiction of Sr. DEN-I & III)

Work contract of supply, fabrication and erection of shed for storage of pipes at Ash Handling Plant, 2x500 MW, ABVTPS, CSPGCL, Marwa.

Design, Procurement, Supply, Fabrication, Erection, Installation and Commissioning of New CS Plant of TPH capacity near High Speed Shaft at Gumgaon Mine.

Fabrication, Supplying and Fixing of 304 grade SS Crossover bench in Bioassay Lab at LG Floor, THSTI Building at NCR BSC Faridabad

CNA-RTM-FTD-UJN Section -Reconditioning of CMS crossings by RW-20 Translamatic Robotic welding technology complete work under the Jurisdiction of DEN/North/RTM.

Mobile Flash Butt Welding of all type of rail panels (60 Kg/52Kg, R260/72/90 UTS, New/In Services) in Chappra - Gorakhpur Cantt Section.

Welding Transformer With All Accessories 400A OCV 60 To 100 V 60 Percent Duty Cycle, Welding Transformer Or Inverter Based Welding Machine With All Accessories 300A OCV 60 To 100 V 60 Percent Duty Cycle, DC Arc Welding Rectifiers Set With All ... GMAW Welding Machine ... GTAW Welding Machine ... Spot Welding Machine ...

Supply fabrication and erection of 400mm and 700mm dia MS pipe including all other appurtenant work under 100 cusec Water supply scheme Ghaziabad

Fabrication of Additional Frame work for Repair of Polyhouses-Renovation and repair wor of existing Polyhouses of maintain Opsertaional Efficiency of ICAR-CITH.

Design, Supply, Fabrication and Installation of safety protection arrangement for personnel working at elevated locations and maintenance activities at Maneri Dam, Maneri Uttarkashi

Fabrication and Errection of Refill Station in T Shape and Making of Short Piece Bend Jointing of Valve etc, at KOCP under ABDKC

DESIGN, FABRICATION, SUPPLY, ERECTION AND COMMISSIONING OF NOx GASES, EXTRACTION AND SCRUBBER SYSTEM WITH ASSOCIATED CIVIL WORKS AT BLDG No. 228 IN HEF

Fabrication and erection of Tail end pulley safety guard and output shrink disc safety guard of gear box at CHP:EXT:MM, HTPS Korba West.

Supply, fabrication, transportation and Erection of Sliding gate of TALAMAREI SLUICE of Binjharpur Block under Drainange Division, Jajpur for the year 2026-27.

Survey, Design, Supply, foundation, fabrication, erection, Testing & Commissioning of Towers in connection with installation of Kavach over Sambalpur division of East Coast Railway.

Custom Bid for Services - Fabrication and Supply of Flanges & Swivel Joint of DSS material Similar Category Piping Erection Service Repair and Overhauling Service

Fabrication and erection of radium base ACP sheet board for guidelines issued for road weighbridges and checkpost of Topa Project under Kuju Area.

Tender for the work of fabrication for various material use for HT/LT line at Dharampur Division under jurisdiction of Dharampur Division office.

Repairing/fabrication of damaged B-phase HV bushing of 132/33 kV, 31.5 MVA Atlanta Make Power Transformer at 132 Kv GSS Jayal

Custom Bid for Services - Development Tasks for radiological applications involving fabrication of Prototype Fixtures, Process Experimental Setups, Customized handling systems, Shielding Arrangements, Remote Handling Trials on Prototype Systems, Leak.. Similar Category Repair, Maintenance and Installation of Plant Systems/Equipments

INVITING TENDER FOR SUPPLY FABRICATION INSTALLATION AND COMMISSIONING OF RAIL SYSTEM AND TROLLEYS FOR HANDLING ICE CREAM CRATES AND CONES