Fabrication Tenders in Jharkhand

Dismantling, fabrication, erection n alignment of Belt structure of 512 n 549 Belt n discharge chute liner of 1001 n 513 Belt under Main Washing Plant of Rajrappa washery Project.

Fabrication of 02 nos. sets of cutting edges and end bits from old and serviceable cutting edge and end bits applicable for wheel dozer WD600 (WD-1) of Amrapali project

Repairing / Fabrication and replacement of rotor shaft and dynamic balancing of 02(Two) no. each of 93KW and 76KW, 1460 rpm, 3Ph., 50Hz. sq. cage induction motor at Sawang Washery.

Repairing of 01 no. radiator, 04 nos. new lift cylinder bush fabrication, tilt adjusting screw, trunnion and tilt guard of dozer D355 Sl. No. P11666 at Tetulmari OCP, Sijua Area.

Fabrication and erection of discharge chute with side guard and its channel, angle and plate etc of unit no. 52 complete dismantling and fitting in RCB Section at Kathara Washery

Complete repairing of ten number of feed sprocket with fabrication of 10 number new pin for eimico elecon Sandvik 160D Drill Sl. No. DR222 and DR204 at ADIC Kusunda Area

Fabrication and Modification of base plate and assembling of parts 4000 GPM and 2000 GPM pump bearing changing, coupling belt changing, greasing, packing etc at Jamunia patch of ABOCP Mine

Fabrication repairing of LH side operator cabin door glass up and down mechanism of 100 Tonne Sl. No. D-90107 and D-90108 at Base Work Shop of Kathara Colliery

Break-up-cum dismantling and repairing and fabrication of C.I. wheel and shaft of both A side shuttle belt conveyors in RCB top of Raw Coal Section of Sawang Washery.

Fabrication and writing by fluroscent paint of safety awareness board, welcome board, Traffic rule board, SOP of Dumping board and caution board at strategic places in Govindpur Ph II OCP

Dismantling , fabrication, erection and alignment of throughing idler support of 1400 mm belts and deck plates, belt structures of 404 B shuttle conveyors under Raw Coal Section of Rajrappa Washery

Fabrication/erection of steel structural work batac jig floor footway, replacement, changing of partition plate of batac jig and stair case repairing etc. work in Deshaling Plant at Sawang Washery.

REPAIRING OF CRACK IN BOOM DRAINAGE SYSTEM OF THE ROOF and FABRICATION and FITTING OF WALKWAY PLATES IN MACHINERY HOUSE OF PandH 2300XPA LR SHOVEL NO RS15 OF RAJMAHAL PROJECT

Fabrication and making of 10inch and 8inch dia MS stainer MS bend and 10inch by 8inch dia reducer for further installation of pumping and pipe line at Muraidih AMP Colliery

Repairing n fabrication of the damaged parts / spare parts of the rotating element of DSM-6 Pump (KGW Shed) as well as its body in respect of IWSP(BnK) Area

Fabrication/ casting of fork of gear box and complete repairing of brake system of Loco no - 204 including repairing of v2j relay, limiting and spanner valve of Sudamdih Coal Washery.

Repairing of operator seat, buddy seat of Dumper-60385, 60386,60387,60388,60392 and Tanker-28003 n 28005 and Rep. of 04 nos. Engine stand fabrication of Dumpers at Govindpur Ph-II OCP

Dismantling and withdrawal of old and damaged mother(impact) plate and fabrication and fitting mother(impact) plate at Feeder Breaker No-1 of Kessurgarh ABOCP Mine under Block -II Area

Repairing and fabrication of operator cabin mounting and cabin guard and painting and radiator repairing / overhauling and fitting of CK300 hydraulic shovel Sl. No. B0776 at Bansdeopur OCP, Sijua Area.

Fabrication of 02 Nos. Safety Gate and Painting of Structure 1 to 4 cage (16 No. deck)400 M.H front and back side shed painting of structure at Moonidih Project

Removing, fitting and repairing of pinion of hoist motor and new fabrication of 02 nos. safety clutch turn buckle of EKG Shovel HMB 481 at Nichitpur OCP of Sijua Area.

Complete dismantling of old and damaged BC-03 receiving feed chute and fabrication and erection of new feed / receiving chute of BC-03 conveyor at Deshaling Plant of Sawang Washery.

Design, Manufacture/Fabrication, procurement of material, shop assembly, shop inspection, painting, testing and delivery of Hydraulic Cylinder and Jack for Reversing Winch, (Pkg. No. SS-401B) F.O.R Bokaro Steel plant

Design, engineering, manufacture, fabrication/ assembly, inspection, shop testing, painting at manufacturer shop, packing, loading and transportation, Supply on F.O.R. Site Basis, Supervision of Erection, testing, trial run and load commissioning...

Mechanical Repair, Maintenance, and Fabrication of 07 Nos. Induction Motors 260kW (Sl. No. 40491305), 200kW (Sl. No. 70328728), 150kW (Sl. No. 30048863), 150kW (Sl. No. 30048868), 150kW (Sl. No. E116AG

Repairing and back fitment of 02 nos. Steering cylinder by seal replacement, eye fabrication as per stub size etc of CAT777D TH8 Dumper of Ashok OCP.Pl refer NIT for details.

For fabrication of new LHS, front railing guard and LHS Catwalk of 02 Nos. of Dumper Sl. No. BH50M-1 Sl. No. 3540 and 3543 at AKWMOCP, Katras Area, BCCL

Repair and fabrication and erection of different motor base structure and strengthening of its associated supporting structure at 13 mtr level of circuit II in HMS Section at Kathara Washery.

Fabrication/Erection of steel structural work for B side grizzly and repairing of fresh water shower pipeline for water sprinkling in both side hopper at P.C.H. Section of Sawang Washery.

Complete repairing and overhauling of 8 inch and 6 inch dia sluice valve and fabrication of foot valve for 2000 and 1000 Gpm pump suction in respect of Karo OCP

Providing , dismantling, fabrication, erection and alignment of damage structure and shade of head drum of 1204 and 1304 and between silo 8 and 9 at loading section of Rajrappa Washery

Fabrication, Errection and commissioning of 03 No. CISF Watch Tower, at K/Dump- 12 Coal Dump, 12/14 No Coal Dump, GOCP Coal Dump at ABCK Colliery Under Bastacolla Area.

Repairing of bearing housing bolt hole proper size making and its thread making stud fabrication etc For 10UPH8 at 4000GPM 150Mtr head pump of ABOCP mine under Block-II Area

Fabrication and Installation of new Grizzly-Bar structures after complete dismantling of existing damaged grizzly no. A-3 and A-4 of raw coal receiving hopper at Moonidih Coal Washery.

Fabrication and fitting of turbo charger guard 15 sets (One set contains one no. of big and One no. of small guard) of 60T Dumper at Dahibari OCP, CV Area.

Fabrication, erection of shade and cover for MCCBs LT switches etc. to protect from rain and also as a safety precaution at Dugda-I, Dugda-II, Mini and Railway transformer

Repairing of steering cylinder (02 No), tilt cylinder (02 No) and lift cylinder (01 No) and fabrication of cylinder pin for Cat 834K Wheel Dozer, Sl. No. - 728 at AKK.

Dismantling, fabrication and erection of motor base structure of unit no. 181 and receiving chute its channel, angle, plate etc. of unit 202 at in RCB Section at Kathara Washery

Fabrication of Handle stopper 02 nos. and repairing of take up axle 01 no. and take up wheel 02 nos. of EKG 5A Shovel Sl. No. HMB 592 of JOCP.

Dismantling and withdrawal of old and damaged mother impact plate and fabrication and fitting of new mother impact plate at feeder breaker No 1 of Muraidih Colliery under Barora Area

Dismantling and withdrawal of old and damaged mother(impact) plate and fabrication and fitting mother(impact) plate at Feeder Breaker No-2 of Nudkhurkhee ABOCP Mine under Block -II Area

Repairing of steering cylinder (02 No), tilt cylinder (02 No) and lift cylinder (01 No) and fabrication of cylinder pin for Cat 834K Wheel Dozer, Sl. No. - 728 at AKK.

Repairing of Track frame, Frame assy, Brace arm, Repairing of Trunion ball, Trunion cap, Cover, Tilt hose cover and fabrication of support of dozer BD355 SI.NO.11523 Of Purnadih Project.

Fabrication/Erection, repairing of 30mtr. thickener feed pipes 1, 2 and 3 nos. with sump inner and outer pipes, valves flanges, boxes etc. work in Main Plant at Sawang Washery.

Fabrication and fixing of 300mm dia suction pipe, 250mm dia delivery pipe and foot valve Matching pieces for running of 4000GPM Pump at NAKC Hired Patch-H under Govindpur Area

Fabrication of bed plates and cutting of MS Angle and channel from Regional Store, Godhur for the same, for installation of pumping system at OCP Patch -B for speedy dewatering

Fabrication/Erection of steel structural for 4th floor slurry tank and valves, feed pipe, U/F pipes, returning pipes dismantling, repairing and re-fitting in Main Plant of Sawang Washery.

Fabrication and erection of RCC tank by pass pipe line 6 inch dia water column to RLB new bunker side including valve fitting etc in RLB Section of Kathara Washery

Dismantling drum pontoon set and fabrication of 03 set of fresh drum pontoon complete set with M.S Plate, Angle, Channel for installation of H.T. Pump at Phularitand under AMP Colliery.

Fabrication and Installation of new Grizzly-Bar Structures after complete dismantling of existing damaged grizzly no. B-1 and B-2 of raw coal receiving hopper at Moonidih Coal Washery.