South Western Railway Tenders

Master setting gauge for dial snap gauge

Servo press 150 RR Oil

DIESEL EXHAUST FLUID

PROTECTION COVER FOR DRAIN COCK

Visitor Chair

Set of Item for Cummins KTAA-19G10 engine. 1 set consist of following items (1) BEARING, Ball Part No. S 16052, Qty.: 02 No. per set, (2) NUT, TAPPET TOP STOP LOCK, Part No. 3279850, Qty.: 01 No. per set, (3) RING RETAINING, Part No. 212604, Qty.: 02 No. per set, (4) SHAFT, FUEL PUMP DRIVE, Part No. 212601, Qty.: 01 No. per set , 01 set consist of 04 items.

E.E.G.PASTE not less than 228 GMS

PLNO.18310242- Circuit Breaker Local Control 30 Amp to EMD Part No. 40037997

Cab Door Lock

ROLLER FOR CURVE DOOR

SUpply of Portable HLI to check air flow

Supply of Bottom Plate for vertical meta

SUPPLY AND FITMENT FOR SET OF ITEMS

Supply set of spares for Fire/Smoke Detection with alarm System of Sanrok make

Supply of spares forFire/Smoke Detection with alarm System

Door spring for lavatory door

BALANCED SALT SOLUTION EACH ML CONTAINING NaCl 0.64%, KCL 0.075 % CACL 0.048% SODIUM CITRATE 0.17% SODIUM HYDROXIDE OR HYDROCHLORIC ACID TO ADJUST PH AND WATER IN 500 ML NON PVC INFUSION SOFT COLLAPSIBLE BAGS WITH SPIKE PORT PACKED IN SEALED POUCH

FIELD TEST KIT WITH MICROBIOLOGICAL MEDIA FOR BACTERILOGICAL ANALYSIS OF DRINKING WATER (H2S Kit)

HDPE Pipe for water supply

Pressure gauge, to Sanrok part no.-029720182 or similar for automatic fire suppression System as per RDSO Specification No. RDSO/2013/CG-06 RI/R2 or latest. It must be compatible with Sanrok make fire system also test report and calibration certificate required.

"SET OF HAND TOOLS CONSISTS OF i. 8 X 9 OPEN END SPANNER- 3 NO ii. 8 X 9 RING SPANNER-3 NO iii. 10 X 11 OPEN END SPANNER-2 NO iv. 10 X 11 RING SPANNER-2 NO v. 12 X 13 OPEN END SPANNER-3 NO vi. 12 X 13 RING SPANNER-3 NO vii. 16 X 17 OPEN END SPANNER-3 NO viii. 16 X 17 RING SPANNER-3 NO ix. 18 X 19 OPEN END SPANNER-3 NO x. 18 X 19 RING SPANNER-3 NO xi. 20 X 22 OPEN END SPANNER-4 NO xii. 24 X 27 OPEN END SPANNER-4 NO xiii. 32 X 36 OPEN END SPANNER-4 NO xiv. 36 X 41 OPEN END SPANNER-4 NO xv. TEE SPANNER 10 MM -3 NO xvi. PIPE WRENCH 14 INCH-2 NO xvii. SOCKET 17,18,19-1 SET (1no each)"

CURVE ROLL for LHB Coaches.

LIFE JACKETS

Bar Code Label 4x4 inches

RUBBER LOBE (Pad) for Trolley Mounted

Supply of Acrylic sheet Transparent

Barcode resin cartridge

PROVISION OF WHEEL WISE LOAD MEASUREMENT BY EIMWB AT CTA

Pressing system for Primary Spring

TOP SIDE BEARER LINER

DISC SIZE 85X12

SHUNT FOR E.P. CONTACTOR TYPE M24PC2 TO BHEL

Anti Rotating clamp for 4.5 KW Alternator Suspension Hanger pin thickness 10mm

LOCK(MALE AND FEMALE) FOR BODY SIDE WINDOW

T-720-F:- Combined train report by guard

Bracket for mounting of S trap

Proposed construction of ROB at LC no 287 between BDKA-UNK section

Double ended grease Dispensing machine

Subwork 1: Signalling works in connection with SUBL-DWR section Provision of W beam metal crash barrier along side the track for a length of 42.06Km. Subwork2: UBL-GDG: Construction/Extension of Limited height subway (LHS) at Km 36/0-010 in Annigeri yard (NGR) at GDG end in UBL-GDG section.

SWR:UBL Div: Reliable working of signaling system by replacement of defective cable over Hubballi Division

trolley-mounted Hydraulic Puller with a capacity of 100/70 Ton

Set of spare kit for 500 A, 750 V, 3 phase, 50 Hz Inter Vehicular coupler for LHB coaches as per RDSO Spec. No. RDSO/PE/SPEC/AC/0177-2013 Rev. 1 or latest. One set consists of: (1) Contact pins with tip assembly for jumper plug assembly R, Y, B, N & E as per RCF drawing No LW71337 Alt 'B'-05 Nos/set. (2) Connector female assembly for R, Y, B, N & E as per RCF drawing No. LW71316 Alt 'D' - 05 Nos/set. (3) Insulating base with fixing screw kit for coupling socket Assembly as per RCF drawing No. LW71303 Alt 'B'- 01 Nos/set. (4) Insulating base with fixing screw kit for jumper plug Assembly as per RCF drawing No. LW71304 Alt 'B'- 01 No/set. (5) Lever tie bow for RH and LH for Ratchet arrangement as per RCF drawing No. LW71360 & LW71361- 01 No/set. (6) Connecting link lever arm for ratchet arrangement as per RCF drawing No. LW71367- 01 No/set. (7) Rivet pin link long for ratchet arrangement as per RCF drawing No. LW71368- 01 No/set. (8) PMA protective sleeve for R, Y, B - 03 Nos./Set (9) PPMA protective sleeve for N & E - 02 Nos./Set. Item to be procured from RDSO approved vendor as per UVAM

Magnetic Base Rail thermometer RDSO Spec

Large span wire 130 sq.mm Stranded Cadmium Copper wire as per RDSO Spec No: TI/SPC/OHE/CAT(Cu-Cd)/0971 or latest.

Custom Bid for Services - Hiring of 01 MUV Non-AC or Sedan Non-AC with driver for a period of 02 years with overall 1500 kms per month for the use of ADME/ASK, Custom Bid for Services - Extra 500 kms per month over and above 1500 kms Similar Category Monthly Basis Cab & Taxi Hiring Services Monthly Basis Cab & Taxi Hiring Services

Internal Storage Device (SSD/HDD) (V2) (Q2)

Medical Centrifuge (Q3)

Audio Amplifier (V3) (Q2)

Online UPS (?10KVA) With Battery Conforming To IS16242 (Part1) (Q2)

PVC Insulated (Heavy Duty) Electric Cables Marked To IS1554 (Part1) (V2) (Q2)