RDSS & Grid EPC Tenders

Repair/ rectification of leakages to water supply distribution lines 15 mm bore to 25 mm bore GI/ PPR tubing with provision of necessary excavation, cutting of hard standing, returning and filling in as required, tightening of loose joints of union, elbow, sockets etc, threading if required including replacement of GI unions/ sockets/ nipples as required at site complete all as specified and directed.

Repair/ rectification of leakages to water supply distribution lines 15 mm bore to 25 mm bore GI/ PPR tubing with provision of necessary excavation, cutting of hard standing, returning and filling in as required, tightening of loose joints of union, elbow, sockets etc, threading if required including replacement of GI unions/ sockets/ nipples as required at site complete all as specified and directed.

Supply, installation, testing and commissioning LT PANEL board outdoor type (CPRI Approved) of suitable size, Kiosk type, factory assembled, fabricated and of suitable size angle iron, channel and MS sheet 3.15 mm thick CRCA Sheet Fabrication+ 7 Tank Process, Powder Coating IP-55, 300 A Aluminum Bus bar with Coloured Insulation Sleev, Formica Sheet, Rubber Gasket, Wiring with Copper wire and Lugs, Misc. Item Like Lock, Hardware etc.double door type, front and rear openable with locking arrangement and duly prewired with colour code three phases and neutral for 415 volts, 50 Hz electric supply with and including suitable sizes of cable glands for incoming and outgoing cables cubical type , grouting of panel 60 cm above the ground level by provisioned 90 cm long angle iron frame bottom of panel 40x40x5 mm thick , welded on all four corners , embedded in PCC 1:2:4 type B-1 using 20 mm graded stone aggregate up to 30 cm and, grouting the panel board on and including suitable size foundation structure with the following components (INCOMMING) (a) MCCB 250 Amps, 4 Pole, 50 KA, 415 Volt, Ics= 100% Icu, (WIN BREAK1) (Incoming) - 01 No. (b) Sprader Terminal WB1CSE2-4 Pole 250A (Set of 4) 0-250 Amps with CT 250/5A rating - 02 Nos (C) DIGITAL METERING-SECURE,DIGITAL VOLT METER 96 X 96- 01 ,DIGITAL AMP. ,METER 96 X 96- 01 VSS- 01,ASS- 01 R-Y-B ,INDICATION LAMP- 1 SET, CONTROL FUSE-03 CT-03 - Qty -01 (d) 250A FP CHANGE OVER (NM) -01 (e) GREEN INDICATION LAMP) - 02 (OUT GOING) (i) Busbar Chamber: 1 Set ( 3 L + 1 N ) Electrically grade Bus bar aluminium of capacity equal to 1.5 times of rated incoming control switch gear including interconnection of all switch gears duly insulated with colour coded heat shrinkable sleeve and mounted on suitable size. (ii)200 A FP 25 KA MCCB (WINBREAK1)catpart No : CSE2M250ATM4 P-* - 04 (iii) Sprader Terminal WB1 CSE2- 4 Pole 160-200 A (Set of 04) - 08 (iv)160 A FP 25 KA MCCB (WINBREAK1) - 02 (v) Sprader Terminal WB1 CSE2 -S- 4 Pole 160- 200 A (Set of 4) - 04 (vi) 125 A FP 18 KA MCCB (WINBREAK1-S) - 01 (vii) Sprader Terminal WB1 CSE-S- 4 Pole 16-125 A (Set of 4) - 02 (viii) 100 A FP 18 KA MCCB (WINBREAK1-S) - 01 (ix) Sprader Terminal WB1 CSE-S- 4 Pole 16-125 A (Set of 4) - 02 ( x) 63 A DP 'C' MCB-C&S - 04

Supply, installation, testing and commissioning LT PANEL board outdoor type (CPRI Approved) of suitable size, Kiosk type, factory assembled, fabricated and of suitable size angle iron, channel and MS sheet 3.15 mm thick CRCA Sheet Fabrication+ 7 Tank Process, Powder Coating IP-55, 300 A Aluminum Bus bar with Coloured Insulation Sleev, Formica Sheet, Rubber Gasket, Wiring with Copper wire and Lugs, Misc. Item Like Lock, Hardware etc.double door type, front and rear openable with locking arrangement and duly prewired with colour code three phases and neutral for 415 volts, 50 Hz electric supply with and including suitable sizes of cable glands for incoming and outgoing cables cubical type , grouting of panel 60 cm above the ground level by provisioned 90 cm long angle iron frame bottom of panel 40x40x5 mm thick , welded on all four corners , embedded in PCC 1:2:4 type B-1 using 20 mm graded stone aggregate up to 30 cm and, grouting the panel board on and including suitable size foundation structure with the following components (INCOMMING) (a) MCCB 250 Amps, 4 Pole, 50 KA, 415 Volt, Ics= 100% Icu, (WIN BREAK1) (Incoming) - 01 No. (b) Sprader Terminal WB1CSE2-4 Pole 250A (Set of 4) 0-250 Amps with CT 250/5A rating - 02 Nos (C) DIGITAL METERING-SECURE,DIGITAL VOLT METER 96 X 96- 01 ,DIGITAL AMP. ,METER 96 X 96- 01 VSS- 01,ASS- 01 R-Y-B ,INDICATION LAMP- 1 SET, CONTROL FUSE-03 CT-03 - Qty -01 (d) 250A FP CHANGE OVER (NM) -01 (e) GREEN INDICATION LAMP) - 02 (OUT GOING) (i) Busbar Chamber: 1 Set ( 3 L + 1 N ) Electrically grade Bus bar aluminium of capacity equal to 1.5 times of rated incoming control switch gear including interconnection of all switch gears duly insulated with colour coded heat shrinkable sleeve and mounted on suitable size. (ii)200 A FP 25 KA MCCB (WINBREAK1)catpart No : CSE2M250ATM4 P-* - 04 (iii) Sprader Terminal WB1 CSE2- 4 Pole 160-200 A (Set of 04) - 08 (iv)160 A FP 25 KA MCCB (WINBREAK1) - 02 (v) Sprader Terminal WB1 CSE2 -S- 4 Pole 160- 200 A (Set of 4) - 04 (vi) 125 A FP 18 KA MCCB (WINBREAK1-S) - 01 (vii) Sprader Terminal WB1 CSE-S- 4 Pole 16-125 A (Set of 4) - 02 (viii) 100 A FP 18 KA MCCB (WINBREAK1-S) - 01 (ix) Sprader Terminal WB1 CSE-S- 4 Pole 16-125 A (Set of 4) - 02 ( x) 63 A DP 'C' MCB-C&S - 04