SPECIAL REPAIR/RENOVATION OF 32 UNITS (STAFF QTR NO B9 TO B 16 AND C9 TO C16) OF STAFF QUARTERS OF SCHOOL BUILDING AT KV NO 1 AT AFS BHUJ

Amount

Demolition of cement concrete of any description and in any position not otherwise specifically provided for and removing excavated material exc 1.5 Km and n,exc 5 Km and where directed

Dismantling floor hearth or wall tiling including cement mortar bedding (but not backing) removing serviceable tiles to store and rubbish off the premises

M&L for 25mm thick cement concrete type B-0 1:2:4 using 12.5mm graded aggregate in floors

M&L for non skid coloured ceramic tiles 7 to 8 mm thick area of each tile exceeding 0.11sqm but not exceeding 0.18 sqm, in floors etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match including 15 cm thick cement bedding in CM 1:6

M&L for non skid coloured ceramic tiles 7 to 8 mm thick area of each tile exceeding 0.11sqm but not exceeding 0.18 sqm, in skirting etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match including 10 cm thick cement backing coat in CM 1:4.

M&L for glazed ceramic coloured tiles in vertical surfaces such as in skirting and dados 350x250x7mm/450x350x7mm thick set and jointed in neat cement slurry and pointed in white or coloured cement to match over including 10 cm thick cement backing coat in CM 1:4.

M&L for 75 mm thick cement concrete type C-2 (1:3:6) using 40 mm graded stone aggregate as in sub base under interlocking tiles.

M&L 60 mm thick (M-35 mix) glossy rubber mould interlocking tiles (paver blocks red & yellow colour topping) conforming to IS-15658-2006 laid dry over and including 30 mm copacted sand bed, size & pattern of tiles all as directed by Engineer-in-Charge Make: Supreme/Lucky Cement Works or equivalent as approved by GE.

M&L PCC type B1 1:2:4 (by using 20 mm graded crushed stone aggregates) as in bed plates, coping, slightly rounded or chamfered angles and throating as directed including necessary formwork complete all as specified.

Taking up on down steel tubing and connection incl cleaning for refining of the following bore of pipe

15mm bore of pipe

20mm bore of pipe

25 mm bore pipe

S&F CPVC pipes ISI marked IS 157778 with all fitting for hot and cold water fixesd with solvent cement complete to walls and ceiling or laid in floors of following sizes (SDR 13.5 of make astral or equivalent of supreme / finolex).

20mm bore of pipe

25mm bore of pipe

32 mm bore of pipe

Refixing old steel tubing and conne-ction in new or old position (wall ceiling, floor etc) with new G.I.fillings of the following bore of pipe

a) 15mm bore of pipe

b) 20mm bore of pipe

c) 25 mm bore pipe

S&F in repairs fancy type bib taps, cast copper alloy with crutch or butterfly handle, screwed down, screwed for iron pipe or for brass ferrule and fixed for size 15mm bore.

S&F stop valve 15 mm dia cast chromium plated screwed down high pressure with crutch or butter fly handle screwed both ends for iron pipe or for unions and fixed in repairs.

S&F Brass CP Mixer for mixing hot & cold water screwed down for iron pipe and fixed in repairs of 15mm bore.

S&F PVC connection 450mm long with check nut for wash hand basin etc complete

S&F in repairs vitreous china wash basin, angle back, size 600x480mm white, excluding taps, waste, chain and plug and porcelain stopper but including brackets.

S&F pillar taps of 15 mm bore, fancy type with capstan head, chromium plated, screwed down high pressure, with long screwed shanks and fly nuts, screwed for iron pipe & fixed.

S&F of waste pipe of 32mm dia PVC pipe for WHB with long screwed shanks and fly nut flange end beddedd in red lead cement and other end fixed

S&F in repairs soap dish any type fixed to plugs with chromium plated brass screws.

S&F in repairs Aluminium anodised tubular towel rail 20mm dia D Type 60cm long between flanges

S&F Vitrious china squattin pan ,Orrissa Pattern Size 580x440 mm white with integral foot rests ( Excluding flushing cistern and flush pipe)

S&F cast iron 'P' or 'S' traps 100 mm bore of pipe.

S/F grating square 150mm size of PTMT (minimum weight 100 gms )

S&F in repairs PVC low level valveless, syphonic action type flushing cistern, low level, white, with inlet, bll valve, flaot and handle including brackets of 10 Ltr capacity.

Taking down cement plaster on walls etc, including racking out joints, hacking for key, scrubbing down with water etc

M&L for 5 mm thick rendering for fair faces of concrete surfaces on ceiling in CM 1:3 for fair finished surfaces.

M&L for 10 mm thick rendering for fair faces of concrete surfaces on walls in CM 1:6 and finished even and smooth without using extra cement as specified.

M&L for rendering on concrete surfaces 15mm thick in two layers first coat 10mm thick in CM 1:6 and second coat 5mm thick in CM 1:4 with water proofing compound @3% by wt of cement, finished even and fair.

Supply only integral water proofing compound (ISI Marked).

M&L for preparation of new or previously untreated concrete extrernal surfaces and applying two coats of exterior emulsion paint all as specified and directed by EIC using any one of following material :- Make Brand Nerolac Suraksha Asian ACE Berger Walmasta

M&L for preparing new plastered ceiling/soffits of chajjas surfaces and applying three coats of white wash complete all as specified and directed by Engineer-in-Charge.

M&L for preparing new plastered wall surfaces and applying two coats of distemper with distemper oil emulsion, white or tinted including one coat of Birla White Putty by finishing the surfaces even and smooth complete all as specified and directed by EIC.

Dismantling of cast iron, PVC or reinforced concrete pipes jointed in cement mortar and taking out of trenches, if required all as directed by Engr-in-charge following bore of pipe

a) 100/110mm dia of pipes

b) 75mm dia of pipe

S&F of UPVC ultra drain,SelFit pipes, single socketed, ISI marked, IS-13592 type 'B' in any length, jointed with solvent cement fixed in walls and floors of following size :- (Make : Astral type 'B' pipes or equivalent)

a) 110mm dia of pipe

b) 75mm dia of pipe

S&F of UPVC junction single 'Tee' equal with door opening, ISI marked, IS-14735, jointed with solvent cement of following sizes :- (Make : Astral type 'B' pipes or equivalent)

a) 110mm dia of pipe

b) 75mm dia of pipe

S&F of UPVC sockets equal, ISI marked, IS-14735, jointed with solvent cement of following sizes :- (Make : Astral type 'B' pipes or equivalent)

a) 110mm dia of pipe

b) 75mm dia of pipe

S&F of UPVC bend equal of any radius with door, ISI marked, IS-14735, jointed with solvent cement for 75mm size pipes. (Make : Astral type 'B' pipes or equivalent)

S&F of UPVC bend equal of any radius without door, ISI marked, IS-14735, jointed with solvent cement for 110mm size pipes. (Make : Astral type 'B' pipes or equivalent)

S&F of UPVC socket reducer 110mmx75mm size, ISI marked, IS-14735, jointed with solvent cement.(Make : Astral type 'B' pipes or equivalent)

S&F of UPVC cowl for 75mm size pipes, ISI marked, IS-14735, jointed with solvent cement. (Make : Astral type 'B' pipes or equivalent)

S&F in repairs of UPVC floor trap, plain with grating, diameter of outlet in 75mm including jointing to waste pipe fixed with solvent cement.(Make : Astral type 'B' pipes or equivalent)

S&F in repairs of UPVC multi floor trap, plain with grating, diameter of outlet in 75mm including jointing to waste pipe fixed with solvent cement. (Make : Astral type 'B' pipes or equivalent)

S&F in repairs of UPVC gully trap 150x110mm,setting and jointing with solvent cement. (Make : Astral type 'B' pipes or equivalent)

S&F in repairs of UPVC 'P' trap 110x110mm,setting and jointing with solvent cement. (Make : Astral type 'B' pipes or equivalent)

S & F in repairs rotational moulded polythene white water storage tank tripple layared (cylindrical , vertical with closed top , ISI marked , ) hoisted and fixed in position all as specd in SSR Part 1 of capacity 750 ltrs including taking down existing tank also including provision of 20 mm bore ball valves , high pressure of PTMT with epoxy coated aluminium rod & high density plastic ball screwed for iron pipe and fixed (minimum wt 455 gms)( Make of tank Sintex cat no CCWS 0075-02-TLW or equivalent of makes given in Appendix B to PS Make of ball valve Prayag or equivalent in polytuff as approved by GE

S&F, in repair 20 mm bore gun metal globe / gate valve with iron wheel head screwed both ends for iron pipe complete all as specified and directed.

S&F, in repair 15 mm bore gun metal globe / gate valve with iron wheel head screwed both ends for iron pipe complete all as specified and directed.

S&F in repairs sink with drainage board made of stainless steel 1 mm thick for kitchen with plugs, washers and including bedding in cement mortar to dwarf wall or including fixing cantilever brackets and connecting union to pipe over all size 915 x 460 mm, bowl size 410 x 330 x 180 mm mm Make : Nirali (Model : elegance small from regular range, glossy) or size 915 mm x 460 mm bowl size 410 x 330 x 178 mm of make : Jayana (Model : Jujpiter sink with Drain board No: SBSD 5 glossy) or equivalent and nearest size of make : Lorrentto, Neelkanth, Diamond.

S&F in repairs stainless steel plate rack made out of 1mm thick stainless steel sheet, overall minimum size 60cm x 90cm and for 6 plates Make Prayag P336 or equivalent as approved by GE

AARTI ENTERPRISES

JOY ENTERPRISE

GOPI CONSTRUCTION

Mepani Construction Company