Vijayawada Division - BZA - GDV & GDV-MTM Sections ( UP & DN): (i) TFTR- Widening/ repair of cess, filling up low lying areas near toe of bank to avoid water stagnation duly providing Toe Bank, providing Prec cast / Cast insitu RCC central & cross drains to limited length where the distance between adjacent tracks is large enough (UP or DN line) in formation of height less than or equal to 3m at various locations for a total length of 2.000Kms. (ii) TFTR- Widening/ repair of cess, filling up low lying areas near toe of bank to avoid water stagnation duly providing Toe Bank, providing Prec cast / Cast insitu RCC central & cross drains to limited length where the distance between adjacent tracks is large enough (UP or DN line) in formation of height greater than 3m at various locations for a total length of 1.00 Kms (sanctioned locations enclosed as Annexure)

Financial Eligibility Criteria: as per Clause 10.2 of Part-I of IRSGCC-2022 and as per Railway Board Advance correction slip No.1 dated 14-07-2022 The tenderer must have minimum average annual contractual turnover of V/N or "V" which ever is less: where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-F (Annexure- VIB of GCC), along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet

Financial Eligibility Criteria: As per Clause 10.2 of IRSGCC-2022 (As per Advanced Correction slip No,1 dated. 14.07.2022 to GCC-2022) and the same is mentioned in para no.10.2 page no. 15 of this tender document. Tenderer should attach Self-attested/ Digitally signed copy of Certificate showing minimum average annual contractual turnover as per Annexure VIB of IRSGCC-2022 (As per Advanced Correction slip No,1 dated. 14.07.2022 to GCC-2022) in Annexure - "F"Page-32 of Master Document - 1 attached to the tender

Similar Nature of Work : " F-IX: Any Civil Engineering work consisting of Earth Work or Formation Treatment/Rehabilitation of Railway Formation." (as per HQrs letter No. W.148/P/SNW/2025 dated 02.12.2025, with the Approval of PCE/SCR)

Technical Eligibility Criteria: as per Clause 10.1 of Part-I of IRSGCC-2022 (a) The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i) Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or (ii) Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or (iii) One similar work costing not less than the amount equal to 60% of advertised value of the tender

(b) (1) In case of tenders for composite works (e.g. works involving more than one distinct component, such as Civil Engineering works, S&T works, Electrical works, OHE works etc. and in the case of major bridges - substructure, superstructure etc.), tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i) Three similar works each costing not less than the amount equal to 30% of advertised value of each component of tender, or (ii) Two similar works each costing not less than the amount equal to 40% of advertised value of each component of tender, or (iii) One similar work each costing not less than the amount equal to 60% of advertised value of each component of tender. Note for b(1): Separate completed works of minimum required values shall also be considered for fulfillment of technical eligibility criteria for different components. (b)(2) In such cases, what constitutes a component in a composite work shall be clearly pre- defined with estimated tender cost of it, as part of the tender documents without any ambiguity. (b) (3) To evaluate the technical eligibility of tenderer, only components of work as stipulated in tender documents for evaluation of technical eligibility, shall be considered. The scope of work covered in other remaining components shall be either executed by tenderer himself if he has work experience as mentioned in clause 7 of the Standard General Conditions of Contractor through subcontractor fulfilling the requirements as per clause 7 of the Standard General Conditions of Contract or jointly i.e., partly himself and remaining through subcontractor, with prior approval of Chief Engineer in writing. However, if required in tender documents by way of Special Conditions, a formal agreement duly notarized, legally enforceable in the court of law, shall be executed by the main contractor with the subcontractor for the component(s) of work proposed to be executed by the subcontractor(s), and shall be submitted along with the offer for considering subletting of that scope of work towards fulfillment of technical eligibility. Such subcontractor must fulfill technical eligibility criteria as follows: The subcontractor shall have successfully completed at least one work similar to work proposed for subcontract, costing not less than 35% value of work to be subletted, in last 5 years, ending last day of month previous to the one in which tender is invited through a works contract. Note: for subletting of work costing up to Rs 50 lakh, no previous work experience of subcontractor shall be asked for by the Railway. In case after award of contract or during execution of work it becomes necessary for contractor to change subcontractor, the same shall be done with subcontractor(s) fulfilling the requirements as per clause 7 of the Standard General Conditions of Contract, with prior approval of Chief Engineer in writing

Note for Item 10.1 of IRSGCC-2022: Work experience certificate from private individual shall not be considered. However, in addition to work experience certificates issued by any Govt. Organization, work experience certificate issued by Public listed company having average annual turnover of Rs 500 crore and above in last 3 financial years excluding the current financial year, listed on National Stock Exchange or Bombay Stock Exchange, incorporated/registered at least 5 years prior to the date of closing of tender, shall also be considered provided the work experience certificate has been issued by a person authorized by the Public listed company to issue such certificates. In case tenderer submits work experience certificate issued by public listed company, the tenderer shall also submit along with work experience certificate, the relevant copy of work order, bill of quantities, bill wise details of payment received duly certified by Chartered Accountant, TDS certificates for all payments received and copy of final/last bill paid by company in support of above work experience certificate

Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.

Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.

Tender value is including escalation of (-)15% (minus Fifteen percent ) on CPWD DSR rates. Tenderer should note this before quoting the rates

delivered in person to the official nominated (i.e. OS/Tenders/Engg)/BZA Division) as indicated in the tender document before closing date for submission of bids (i.e. excluding the last date of submission of Bids)

All the instructions furnished in the Technical Compliance / Commercial Compliance / Custom / Undertakings / General Instructions are only indicative and not exhaustive. The tenderer shall read the GCC / Tender documents for complete details

The tenderer shall thoroughly go through the entire tender document and strictly adhere to the instruction and directions given therein