Servicing of AHU, AC and REF System on MV Vishva Vijay

Amount

E22031: ITEM : ACCOMODATION BLOWER (AIR HANDLING UNIT OF ACCOMODATION AIR CONDITIONING) TYPE / CAPACITY / DETAILS : TYPE -

BLOWER TO BE OVERHAULED.DYNAMIC BALANCING TO BE DONE.BOTH FWD AND AFT PEDESTAL BEARING TO BE RENEWED.BEARING VENDOR SUPPLY.

EVAPORATOR TO BE CLEANED WITH CHEMICAL SPRAY/WASHING. TO BE PRESSURE TESTED,DEFECTS ANY TO BE REPAIRED.

HEATER TO BE CHECKED.STEAM LINE FOR HEATER TO BE CHECKED AND TRAPS TO BE CLEANED.

AHU INTERNALS TO BE CLEANED DAMAGE TRUNKING TO BE REPAIRS.FLAPS TO BE CHECKED FOR PROPER OPERATION AND REPAIR IF ANY DEFECT.

E22048: ITEM : ACCD AIR CONDITIONING SYSTEM AND PROVISION REFRIGERATION SYSTEM TYPE / CAPACITY / DETAILS : MAKE- HI AIR KOREA MODEL- CMO-38 NO OF CYLINDER-08. PROVISION COMPR- HI AIR KOREA TYPE- CRKC 221014.

AC PLANT, SYSTEM GAS TO BE PUMPDOWN AND COLLECTED SYSTEM TO BE PRESSURE TESTED/ VACCUME TESTED AND SYSTEM LEAKAGES TO BE CHECKED AND RECTIFIED IF ANY LEAKAGES FOUND IN BOTH HIGH PRESS SIDE AND LOW PRESS SIDES. AFTER ABOVE CHECKS SYSTEM TO BE BLOWN THRUOGH . ALL EXPANSION VALVES AND SOLENOID VALVES TO BE CHECKED FOR ITS OPERATION ALL MANUAL VALVES OVERHAULING TO BE CARRIED OUT. SYSTEM TO BE PRESSURE TESTED,VACUUM TEST TO BE CARRIED OUT,GAS CHARGING AND TRIALS TO BE CARRIED OUT.REQUIRED SPARES TO BE ARRANGED BY VENDOR. SYSTEM PIPE LINES IF DAMAGED THE SAME TO BE REPLACED BY VENDOR.PIPE LINES TO BE ARRANGED BY VENDOR

BOTH A/C AND PROVISION COMPRESSORS 02 NOS EACH TO BE OVERHAULED SUCTION DISCHARGE VALVE ASSY TO BE CHECKED PISTON PISTON RINGS OIL PUMPS CONNECTING RODS TO BE CHECKED ALL DEFECTIVE SPARES TO BE RENEWED. QUOTE FOR ABOVE JOB SCOPE INCLUDING SPARES VENDOR SUPPLY.

PROVISION FRIDGE SYSTEM TO BE CHECKED FOR LEAKAGES SYSTEM TO BE PRESSURE TESTED AND LEAKAGES TO RECTIFY.COMPRESSOR TO BE OVERHAULED.ALL COLD ROOM EVAPORATOR TO BE CHECKED.FAN MOTOR TO BE OVERHAULED.EXPANSION VALVE TO BE CHECKED FOR PROPER FUNCTIONING.SYSTEM CONTROLLER TO BE CHECKED FOR PROPER FUNCTIONING.

ECR AC SYSTEM TO BE CHECKED.COMPRESSOR TO BE RENEWED. DAMAGED COMPONENTS TO BE OVERHAULED.COMPRESSOR WILL BE SUPPLIED BY SHIP.SYSTEM TO BE PROVED FOR SATISFACTORY OPERATION TO SHIP STAFF.SYSTEM TO BE PRESSURE TESTED,VACUUM TEST TO BE CARRIED OUT,GAS CHARGING AND TRIALS TO BE CARRIED OUT.REQUIRED SPARES TO BE ARRANGED BY VENDOR

Maker : DONG HWA ENTEC System Particulars : SHELL AND TUBE TYPE SURFACE AREA: 15.75 M2. SHELL SIDE:- FLUID - FW FLUID RATE: 70 M3/H OPERATING PRESSURE: 2.0 KGF/CM2G TUBE SIDE:- FLUID - STEAM FLUID RATE: 1773.8 KG/H OPERATING PRESSURE: 7 KGF/CM2G.

ACCOMODATION A/C SYSTEM CONDENSSOR TUBE STACK TO BE CHEMICALLY CLEAN & PRESSURE TEST CARRIED OUT IF ANY TUBE IS LEAKING SAME TO BE RENEW

E22027 CONTROL AIR DRYER (SURVEY) Maker : KYUNG NAM System Particulars : TYPE: REFRIGERATED (KADM-200) CAPACITY: 170 NM3/H

CONTROL AIR DRYER. TO FIT NEW COMPRESSOR (SHIP SUPPLY) & CONNECT PIPELINES. COMMISSION THE UNIT INTO OPERATION. CLEAN & SERVICE. LEAKAGE IN THE SYSTEM HAS TO BE RECTIFIED & OPERATION TO SHOW..SYSTEM TO BE PRESSURE TESTED,VACUUM TEST TO BE CARRIED OUT,GAS CHARGING AND TRIALS TO BE CARRIED OUT.REQUIRED SPARES TO BE ARRANGED BY VENDOR

GHR MARINE TRAINING AND CERTIFICATION SERVICES PRIVATE LIMITED