REPAIR TO HARDSTANDING PATHS FENCING AND GATES OF MD ACCN IN DOMESTIC AREA AT AF STN BHUJ

Amount

Demolition of cement concrete unreinforced in ground floors and pavings n.exc 15cm thick (below or above ground level)

M&L for 75 mm thick cement concrete type C-2 (1:3:6) using 40 mm graded stone aggregate as in sub base under interlocking tiles.

M&L 60 mm thick (M-35 mix) with grey cement and pigment, glossy rubber mould interlocking tiles (paver blocks red & yellow colour topping) conforming to IS-15658-2006 laid dry over 30 mm thick compacted sand bed, size & pattern of tiles all as directed by Engineer-in-Charge. Make Supreme/Mehtab or any other ISI marked as approved by GE

Dismantling chain link fencing wiremesh, any type, complete all as specified and as directed by the EIC.

Dismantling posts or struts (Wood, Steel or RCC), any section embedded in concrete, brick work etc. including taking out embedded portion.

Excavation in trenches n.exc 1.5 mtr wide and n.exc 1.5 mtr deep for foundation etc or for shafts, wells, cess pits, man holes, pier holes etc n.exc. 10 sqm on plan and n exc 1.50m in depth and getting out in soft/loose soil.

M&L for formwork to sides and concrete foundations, footings ,bases of coloums ,and similar work verticle or to batter complete all as specified and directed by engr in charge.

Returning, filling in, including spreading, levelling, watering and well ramming in layers n.exc 25cm in soil

Removal of excavated material (soils) to a distance n.exc 50 mtrs and depositing where directed at a level n.exc 1.5 mtr above the starting point.

M&L for cement concrete 1:3:6 type C-2 using 40mm graded aggregate as in foundation, filling and mass concrete

S&F chain link fencing plastic coated of size 75 mm x 75 mm, made out of 4.00 mm outer dia, straining bolts etc. including provn of binding wire or with nuts/bolts.

M & L for 10 mm dia and over deformed or twisted bars cut to length bent to shape reqd incl cranking, bending, hooking ends and binding with mild steel wire (anealed) not less than 0.9 mm dia as in line bars for securing chain link fence etc.,

S&F mild steel posts and struts in fencing , flat iron as in wind ties for roof including securing bolts, including cutting tops to shape as directed, drilling holes, notching for wire etc, flat iron fillets for securing wire mesh and similar work confirming to Fe-290 Gde E-165

Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering, Doors etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete

S&F Mild steel bolts, machine made, with hexagonal or square head one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, exc 05 cm but n exc10cm of 11to 15mm dia of neck complete all as specified and directed by Engr in Charge.

M&L for preparation of new or previously untreated surfaces of any description, not otherwise described, over 10 cm in width or girth and applying two coat of synthetic enamel paint over one coat of red oxide primer on new steel surfaces al as specified.

M&L for preparing of surfaces of any description, not exc 10cm in width or girth nd applying two coat of synthetic enamel paint over one coat of red oxide primer on new steel surfaces al as specified.

BHAVANI PROVISION STORES