Loading…
Loading…
Tender Value
₹2.5 Cr
EMD Value
₹4.9 L
Closing Date
21 Oct 2026, 3:00 pm
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
MAINTENANC
14 conditions · 3 needing a document upload
Eligibility in terms of Turnover: The tenderer must have minimum average annual contractual turnover of V/N or V crores; whichever is less where V=Advertised value of the tender in crores of Rupees N=Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of" total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. Tenderers should upload/submit to this effect any of the following authentic documents/certificates as per Annexure-FB for evaluating the above financial eligibility criteria:(a) Attested Certificates(s)issued by Executive or Nominated Authority of the government Departments or Semi- Government/Public Sector Undertakings for the value of the work done for them during the qualifying period. Agreement-wise and Date-wise or attested photo copy of such certificates. Such certificates will be accepted only from Govt./Govt. bodies/PSUs authorities. Certificates issued by Private Bodies will not be considered. (b) Audited Balance Sheets clearly indicating contractual receipts from the works done for Govt./Govt. bodies/PSUs/Pvt. Organization in the P&L Account of the balance sheet duly certified by the Chartered Accountant for the completed Financial years/Certificate from Chartered Accountant duly supported by Audited Balance sheet. NOTE:(i)Financial Year shall normally, be reckoned as 1st April to 31stMarch of the Next Year. However, for Turnover Criteria, the Financial Year as applicable to the Company/Tenderer is to be considered, if it defers from the above. (ii) Current Financial year is reckoned as the incomplete Financial year in which the date of tender submission falls.(iii)Chartered Accountant statements duly indicating yearly receipts will not be considered until and unless backed by Audited Balance Sheets, Profit & loss account Statements. (iv) If the tenderer is not accompanied by the certificates(s) in support of financial eligibility as above, the tender shall be rejected. No post-tender correspondence will be entertained. (v)Attestation of documents may be self attested or attested by a Gazetted Officer.
Similar nature of work for this purpose shall be "Execution of telecom works of OFC/Quad cable OR LAN/WAN/MAN/Data connectivity OR Integrated Passenger Information System in Railways OR Any zonal telecom works OR VSAT terminals OR IP based Exchange OR CCTV OR VHF/UHF/LTE//Radio/Wi-fi/wireless communication OR PDH/SDH/DWDM/IPMPLS in Railways, Metro Railways, LRT, Monorail, suburban transit system, High Speed Railways or any other Government PSUs or any Government Organization".
Eligibility in terms of Experience:(a)The tenderer must have successfully completed or substantially completed any of the following during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or One similar work each costing not less than the amount equal to 60% of advertised value of the tender. (b)(1) In case of tenders for composite works (e.g. works involving more than one distinct component, such as Civil Engineering works, S&T works, Electrical works, OHE works etc. and in the case of major bridges - substructure, superstructure etc), tenderer must have successfully completed or substantially completed any of the following during last 07(seven)years, ending last day of month previous to the one in which tender is invited: Three similar works each costing not less than the amount equal to 30% of advertised value of each component of tender, or Two similar works each costing not less than the amount equal to 40% of advertised value of each component of tender, or One similar work each costing not less than the amount equal to 60% of advertised value of each component of tender. Note for b(1): Separate completed works of minimum required values shall also be considered for fulfillment of technical eligibility criteria for different components. (b)(2) In such cases, what constitutes a component in a composite work shall be clearly pre- defined with estimated tender cost of it, as part of the tender documents without any ambiguity.(b)(3)To evaluate the technical eligibility of tenderer, only components of work as stipulated in tender documents for evaluation of technical eligibility, shall be considered. The scope of work covered in other remaining components shall be either executed by tenderer himself if he has work experience as mentioned in clause 7 of the Standard General Conditions of Contract or through subcontractor fulfilling the requirements asper clause 7 of the Standard GCC or jointly i.e., partly himself and remaining through subcontractor, with prior approval of Chief Engineer in writing. However, if required in tender documents by way of Special Conditions, a formal agreement duly notarized, legally enforce able in the court of law, shall be executed by the main contractor with the subcontractor for the component(s) of work proposed to be executed by the subcontractor(s), and shall be submitted along with the offer for considering subletting of that scope of work towards fulfillment of technical eligibility. Such subcontractor must ful-fill technical eligibility criteria as follows :The subcontractor shall have successfully completed at least one work similar to work proposed for subcontract, costing not less than 35% value of work to be subletted, in last 5 years, ending last day of month previous to the one in which tender is invited through a works contract. Note: For subletting of work costing up to Rs.50 lakh, no previous work experience of subcontractor shall be asked for by the Railway. In case after award of contract or during execution of work it becomes necessary for contractor to change subcontractor, the same shall be done with subcontractor(s) fulfilling the requirements as per clause 7 of the Standard GCC with prior approval of Chief Engineer in writing.
16 conditions · 6 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
The rates includes all present and future taxes GST also.
S&T arrangements for major upgradation under Amrit stations at 13 stations (AD, MALM, GY, DHNE, TU, RJP, KHT, PAK, KRY, MPL, PIL, ATP & DMM) including shifting of S&T assets.
01-SNT-16-2026~SCOR
01-SNT-16-2026
Open
Works - General
12 Months
Anantapur, Andhra Pradesh
₹0
₹4.9 L
29 Sept 2026
29 Sept 2026
7 Oct 2026
70 items across 4 schedules
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| Supply of GKP type Location Box Full size as per drg. No. S&T/MFT/T.2378 Inspection by RITES. | — | 40.00 | — | — | |
| Supply of GKP type Location Box Half size as per drg. No. S&T/MFT/T.2378 Inspection by RITES. | — | 40.00 | — | — | |
| Supply of relay fixing frame for full location box. The frame shall be of approximate size 940mmx150mm and made with powder coated MS angle of 25mmx25mmx 3mm. The frame shall have suitable holes to fix in full location box. Inspection by Consignee. | — | 40.00 | — | — | |
| Supply of relay fixing frame for half location box. The frame should be of approximate size 470mmx150mm and made out with powder coated MS angle of 25mmx25mmx3mm. The frame should have suitable holes to fix in half location box. Inspection by Consignee. | — | 40.00 | — | — | |
| Supply of Terminal block: 1 way Poly butylene Terephthalate (PBT) of size 60mm (link centre to centre) as per RDSO DRG. No. SA23745/Alt.5 or latest, SA23746/Alt.5 or latest, S23747/Alt.5 and specifications IRS: S 75-2006 Rev. 2.0 (Tentative) or latest, IRS: S 23-88 Amd. 1 or latest. Inspection by RDSO. | — | 100.00 | — | — |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
SpecialConditions.pdf
ATTACHMENT
GCC-April2022.pdf
ATTACHMENT
ammendmentCS12ofApril2022_compressed.pdf GCCApril2022Amendment
ATTACHMENT
FormsandAnnexures.pdf
ATTACHMENT
JPOSTCablecut.pdf
ATTACHMENT
GCCUpdateduptoACS-12_02_09_26.pdf
ATTACHMENT
ammendmentCS12ofApril2022_compressed.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .