SURFACING WKS FOR GSB150 MM, WMM100 MM DBM60 MM, PRIME, TACK COAT BY BITUMEN EMULSION, BC40 MM THK BY TACK COAT AND PROV, FIXING OF RD STUD100X100 MM, RD MARKING WITH THERMOPLASTIC PAINT 2.5 MM THK BTW KM0.00-KM10.00 ON TIDANG-BIDANG-JOLINGKONG RD

SURFACING WORKS BETWEEN KM 0.00 TO KM 10.00 ON TIDANG-BIDANG-JOLINGKONG ROAD

GSB 15 cm thick (compacted) with stone aggregate conforming to grading No 1 as per Table -400-1 of MORT&H specifications for Road and Bridge Works including supply of material, watering and compaction all complete for laying of Utility Duct.

GSB 15 cm thick (compacted) for GSB layer and hard Shoulder with stone aggregate conforming to grading No 1 as per Table -400-1 of MORT&H specifications for Road and Bridge Works including supply of material, watering and compaction all complete.

Providing, laying, spreading and compacting graded stone aggregate grading as per Table-400-13 and satisfying the physical reqmt as per Table No. 400-12 of MORT&H specifications for WMM specifications to a thickness of 100 mm, including premixing the material with water to OMC in mechanical mix (Pug Mill) laying in uniform layers in sub base/base course on a well prepared base and compacting with power vibratory roller to achieve the desired density including guarding.

Providing and laying 60 mm thick DBM layer with precoated stone aggregate physical requirements/grading/mix composition requirement as per Table - 500-8/9/10 respectively of MORT&H specifications for road and bridge works with minimum 4.50% asphalt VG-10 penetration grade as per MoRT&H data book and rolled to the required specification. (Fifth Revision)

Providing and laying 40 mm thick BC with precoated stone chips grading confirming to Table:500-17 and mix satisfying the physical requirementt of table 500-16 of MORT&H specifications, mixed with minimum 5.4% binder asphalt VG-10 penetration grade by weight of total mix and 2% cement by weight of mix (for filler) all as specified as per MoRT&H data book.

Providing and applying Prime Coat with bitumen emulsion on prepared surface of granular base including clearing of road surface and spraying primer @ 7.50 Kg per 10 sqm.

Providing and applying Tack Coat with bitumen emulsion using emulsion pressure distributor @ 2.5 Kg/10 Sqm on prepared bituminous/granular surface cleaned with mechanical broom, all complete as per clause 503 of MoRT&H specifications.

Road marking with Thermoplastic Paint (2.5 mm thick) conforming to MoRT&H: 803.4 and IRC-35-2015 including preparation of surface and application.

Providing and fixing of Road Stud 100x100 mm, diecast in aluminium, resistant to corrosive effect of salt and grit, fitted with lens reflectors, installed in concrete or asphaltic surface by drilling hole 30 mm upto a depth of 60 mm and bedded in a suitable bituminous grout or epoxy mortar, all as per BS:873 (Part 4) 1973.