general funds

Supplying of hot applied thermoplastic road marking compound, 2.5mm thick including reflectorsing glass beads @ 250gms with reflectorising glass beads on bituminous surface at 250 gms per sqm area, thickness of 2.5mm is exclusive of surface applied glass bead as per IRC:35, the material should be of BERGER company /BERGER equivalent and must comply with the following: a) White index for the product should be in the range of 60-70 when measured against standard reference. The applied panel 7/8 number must be submitted for checking up the white index in the department lab. In case the department approves the white index of any vendor, the department engineer may carryout random checking of the applied products at site against the approved panel. In case of any major deviation, beyond acceptance limit, department reserve the right to cancel or reject the total supplied consingment of the said material and will compell the vendor has to repalce the full consignment by the desired material as per approved panel at his own cost and additional demurrages may be claimed due to loss of man days (as per the rules of the department) b) Luminance factor of the material should be in the range of 80-85% at 45degree centigrade as per AASTHOM 249. c) Crack resistance: The applied panel cured for 7 days under ambient condition and then should be tested as per BS3262, part-i 1989 and should pass at the range of 0 degree centigrade to -10' degree centigrade Dl Adhesion: Strong E) Softening point:102 degree centrigrade F) Dried film finish: Smooth and uniform 0) Night vision: High as directed by the Engineer-in-Charge and confirming to 5:164-1961 list revision reaffirmed in 1986) and clause conforming to IRC 35-1997

Supplying & fixing of twin Molded shanks raised pavement markers made of polycarbonate and ABS molded body and reflective panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face and shall support a lead of 16000Kg tested in accordance to ASTM D 4280, type H complying to specifications of Category A of by M0RT&H circular no RW/NH - 33023/10-97 - DO Ill dated 11-6-1997. The height, width and length shall not exceed 50mm, 100mm and 100mm with minimum reflective area of 13 sqm on each side and the slope to the bose shall be 35+!- 5 degree. The strength of detachment of the integrated cylindrical shanks (of diameter not less than 19+/-2mm and height not less than 30+/-2mm) from the body is to the a minimum value of 700 Kgs. Fixing will be by drilling holes on the rood for the win shanks to go inside without nails and using epoxy resin based adhesive as per manufactures recommendation and complete as directed by the engineer