PROVIDING STREET LIGHTING AND SOUND SYSTEM AT SRI BRAMARAMBA MALLESWARA SWAMY VATI TEMPLE(SIVALAYAM) AT UP HILL OF S V S DEVASTHANAM, DWARAKA TIRUMALA

Supply Installation Testing and commissioning of free standing floor mounted dust and vermin proof compartmentalised cubical panel made out of CRCA sheet, required hardware, duly painted by two coats of zinc/red oxide primer followed by Powder coated / epoxy / PU painted with phosphatisation in grey or required shade after rinsing. The panel having PU/Neoprene rubber gasket of not less than 3mm thickness,separate detachable, gland plate M.S. base channel, hinged door with locking arrangement for equipment/switchgear. Thickness of sheet shall not be less than 1.6mm up to 600mm length/width of any compartment and be of 2.0mm above 600mm. Loadbearing structure shall be of 2.0mm thick sheet supported by base M.S. channel if required. Side walls and cable alley compartments having bolted type doors with detachable extension type structure (only outer area on all sides shall be measured and panel to be fabricated from CPRI approved fabricator).

Supply and fabrication and erection of following sizes of 4Nos of aluminum bus bars in the existing sheet steel enclosure with resin cast insulator supports etc., complete including cost and conveyance of all materials all labour charges. (50x6mm)

Supply and fabrication and erection of following sizes of 4Nos of aluminum bus bars in the existing sheet steel enclosure with resin cast insulator supports etc., complete including cost and conveyance of all materials all labour charges. (25x6mm)

Supply of 250A 4 Pole MCCB,36/35 KA, Adjustable, Confirms to IS/IEC 60947-2 and IS 13947-part1&2 having Breaking Capacity 36/35 KA with thermal magnetic release Panel Mounted. Makes:Lauritz Knudsen (formerly L&T) - D shine / Schneider-CVS/Legrand –(DP X3/DRX)/ Siemens- 3VL / Hager-h3/C&S -Winbreak/HPL-Techno /ABB (Formula DSP)

Supply of 160A 4 Pole MCCB,25 KA, Adjustable, Confirms to IS/IEC 60947-2 and IS 13947-part1&2 having Breaking Capacity 25 KA with thermal magnetic release Panel Mounted. Makes:Lauritz Knudsen (formerly L&T) - D shine / Schneider-CVS/Legrand –(DP X3/DRX)/ Siemens- 3VL / Hager-h3/C&S -Winbreak/HPL-Techno /ABB (Formula DSP)

Supply of 63-100A 4 Pole MCCB,16 KA, Adjustable, Confirms to IS/IEC 60947-2 and IS 13947-part1&2 having Breaking Capacity16 KA with thermal magnetic release Panel Mounted. Makes:Lauritz Knudsen (formerly L&T) - D shine / Schneider-CVS/Legrand –(DP X3/DRX)/ Siemens- 3VL / Hager-h3/C&S -Winbreak/HPL-Techno /ABB (Formula DSP)

Supply and laying of one number double walled corrugated (DWC) HDPE pipe of following sizes having corrugation on the outer wall and plain surface inner wall confirming to IS : 14930 Part - I and II complete with necessary HDPE fittings for protection of 1.1 KV grade U.G cable directly in ground at a depth of 60Cms including excavation and refilling the trench as required Makes: DURA LINE (Dura guard)/Precision/CPE/Million(AJUSS) or any ISI make approved by CE Electrical.

Supply and laying of one number double walled corrugated (DWC) HDPE pipe of following sizes having corrugation on the outer wall and plain surface inner wall confirming to IS : 14930 Part - I and II complete with necessary HDPE fittings for protection of 1.1 KV grade U.G cable directly in ground at a depth of 60Cms including excavation and refilling the trench as required Makes: DURA LINE (Dura guard)/Precision/CPE/Million(AJUSS) or any ISI make approved by CE Electrical.

Foundation and erection charges with special T&P, for 7.50 Mtrs long Octagonal /Conical pole duly erecting on base plate duly providing 4 Nos foundation bolts with nuts with providing of 0.45Mtr x 0.45Mtrs x1.20 Mtr size M20 cc work vibrated concreting mixing with necessary steel (10kgs) reinforcement and curing for 7 days as directed by the field engineers during execution including excavation of Earth/BT all labour charges and cost and conveyance of materials etc., complete.

Supply of 7.00 M high, cast iron & GI pipe based decorative lamp post including decorative single arm bracket suitable for mounting suspended type decorative light fixture and the top portion of the bracket featuring Cast Aluminium based Holy symbols associated with Lord Shiva as per approved design and approved make. The 7 M High decorative poles shall be supplied in 3-major parts. The first part consisting of 5.30 M hight decorative pole manufactured in a combination of 10-12 mm shell thickness-based Cast lron decorative base pan of 1940 mm H x 140 mm OD x 420 mm base width and 114 mm OD Gt pipe with Ct decorative rings at suitable intervals. The second part consisting of 1.70 M High x 1 M Wide single arm bracket in a combination of 60 mm OD and 42 OD GI pipe and 10-12 mm thick., Cast iron decorative pans suitable for mounting suspended type decorative light fixture and cast Aluminium based Holy symbols such as: Nandi or Elephant or Spider or Snake around Shivling, The third part consisting of Horizontal Nammam wlth reflective stickers, Trishul, and cast Aluminium based Holy symbcls such as: Nandi or Elephant or Spider or Snake around Shivling and shall include supply of 2-nos of 4W to 5W LED Focus lights for holy symbols placed on the bracket and 2 nos of 7W to 8W LED Focus lights for Nammam / Trishul. The lED Focus lights shall be of lP-65 rating with 2-years warranty. The cast iron decorative part of the pole shall be equipped with suitable space with service window for connections and terminations and shall incorporate 4 nos of pre-punched holes at its base of 23 mm dia suitable for fixing 20 mm dia x 750 mm length J-type foundation bolts confirming to ENgGr. The Cast lron decorative parts shall be manufactured confirming to Grade FG 150, GI Tubular pipes shall be confirmingto tS 1239: {pan 1}-2004 and cast Aluminium parts shall be manufactured confirming to LM 6 of BS 1490:1998 / Grade 4600 of tS 617:1994. The decorative pole and its entire part shall be proteded with 4-layer painting system consisting of one coat each of epoxy primer, epoxy colour paint, polyurethane colour paint in antique finish and finally topped with polyurethane lacquer totalling to approximate Dry Film Thickness (DFT) of 80 to 10O micron (Colour shade: Combination of Antique Copper & Gold shade) prices shall be inclusive of standard packing and forwardin& transit insurance and transport charges up to Dwarka Tirumala, Andhra Pradesh

Supply of suspended type weather proof and aesthetically contoured decorative integrated LED Luminaire made from casting and spinning parts of Aluminium with welded cast aluminium based floral motifs on its exterior body with clear optical glass dome as per approved model (DGL- 101-L) measuring approximately 670 mm dia x 700 mm high at its maximum contours with enhanced protedion against ingress of dust/moisture/insects inside the optical compartment having IP 66 rating for LED Drivers, impact Resistance rating of IK-08 confirming to lEC62262:2002, Luminaires confirming to IS: 10322 & LM 79 parameters and compatible to average ambient temperature range of 20 to +50 oC, driver mains voltage of 22O-24OV / 50 Hz with 6500 K CCT +/- 500 K CCT (Cool White) with high grade heat sink in extruded aluminium with silicon compound used for PCB heat transfer. The decorative LED Luminaire shall have system power of 150W +/- 10% with Polycarbonate lens for uniform photometric distribution. The luminaire efficiency shallbe greater than 120 W, CRI > 70, operating power factor > 0.95, THD < 10% and driver efficiency > 85%. The luminaire shall have the useful life as per L8OB1O standards up to 50,000 hours. The luminaire shall have an in-built surge protection of Surge protedion of 5 kVA and external surge protection of 10 kVA with in built auto cut off arrangement to save from abnormal power fluctuation. The main structure of the LED Luminaire shall have a tilting frame for access to the electric & optical auxiliary compartment with silicon gaskets and shall be supplied with approx., 100-150 mm length wiring and suitable connector / adapter. The metallic parts of the decorative LED luminaire shall be protected with 4 coat painting system (Colour: Combination of Antique Copper & Gold) comprising of one coat each of Epoxy primer, Epoxy paint, polyurethane paint and finally topped with Polyurethane Lacquer totalling to 80-100 microns DFT for enhanced corrosion protedion and for giving pleasing appearance. The LED Driver shall have a warranty period of 2-years. prices shall be inclusive of standard packing and forwardin& transit insulilnce and transport charges up to project site at Dwaraka Tirumala, Andhra pradesh

Supply and transportation of 95 Sqmm 3.5 Core XLPE insulated armoured alluminium cable, 1100V grade armoured alluminium cable as per specification confirming to IS:7098 (Part - I)./1554-I.Makes: Torent / Universal / Unicab / Havells / Finecab / KEI / Gloster/ Polycab /RR Kabel/ Fortune Arrt /KEC Asian Cables/Orbit/Avocab /Gemscab /Batra Henlay.

Supply and transportation of 16 Sqmm 4 Core XLPE insulated armoured alluminium cable, 1100V grade armoured alluminium cable as per specification confirming to IS:7098 (Part - I)./1554-I.Makes: Torent / Universal / Unicab / Havells / Finecab / KEI / Gloster/ Polycab /RR Kabel/ Fortune Arrt /KEC Asian Cables/Orbit/Avocab /Gemscab /Batra Henlay.

Labour charges for run of U.G cable on wall / existing pipe with necessary fixing arrangments such as saddles, clamps,wooden separators etc., (as directed by departmental official) with No.10 SWG G.I wire for eath connections for the cables. For 95 Sqmm UG Cables

Labour charges for run of U.G cable on wall / existing pipe with necessary fixing arrangments such as saddles, clamps,wooden separators etc., (as directed by departmental official) with No.10 SWG G.I wire for eath connections for the cables. For 16 Sqmm UG Cables

Supply and making one end termination with heavy duty double compression brass gland as per BS 6121:2005 ,IP 66 complete,SIBG type,heavy duty Alluminium lugs duly crimped with crimping tool, PVC tape etc for following size of Armoured PVC insulated & PVC sheathed/ XLPE aluminium conductor cable of 1100 volt grade as required of size.make:Dowels/Comet/SMI For 95 Sqmm UG Cables

Supply and making one end termination with heavy duty double compression brass gland as per BS 6121:2005 ,IP 66 complete,SIBG type,heavy duty Alluminium lugs duly crimped with crimping tool, PVC tape etc for following size of Armoured PVC insulated & PVC sheathed/ XLPE aluminium conductor cable of 1100 volt grade as required of size.make:Dowels/Comet/SMI For 16 Sqmm UG Cables

Supply and fixing of 1 Nos 10A SP MCBs in existing M.S box with Din channel, 4way 63A connector including cost & conveyance of all materials and labour charges etc., complete of make : Legrand-DX3 / Schneider-A9/Hager-h3/ Siemens-5SX4/ Havells STADx / Lauritz Knudsen (formerly L&T)-AU/Indo Asian-Opti pro/ HPL (Techno) /Anchor (Uno Plus)/ABB-SB200

Supply and run of 2 core 2.5 Sqmm .PVC insulated and sheathed FRLS copper round cable for voltage up to 1100V as per IS 694/1990. in existing pipe for mains inlcuding all labour charges etc., complete of make: Finolex / RR kabel / Havells/ Finecab /KEI/Polycab/ Gloster/ Goldmedal/GM// Fortune Arrt/Anchor /Million/Sudhakar/Orbit/Batra Henlay.

Supply and Run of 25mm x 3mm G.I Strip including cost of all accessories and labour charges etc., complete.

Providing earth electrode of low carbon steel rod, UL listed of 17.2 mm dia, 3 Mtr long, coated with copper of 254 microns thickness, CPRI tested for short time current withstand test of 25 kA, coating thickness, environmental test (Salt Mist Test), Bend test, Tensile strength, Yield / tensile ratio, Electrical Resistivity test, complete with clamps and 2 bags of (Earth plus ULTRA /TIRUMALA) high grade earthing compound IEC 62561-7 complaint Eco-friendly, Maintenance free, anti-corrosive, lead-free, super conductive, mineral based high-grade earthing compound, to enhance soil conductivity. With resistance <0.20 ohms-meter, should be leach proof & Sulphur free complete with earth inspection chamber of dimensions: width: 320 mm x 320 mm, Height : 192 mm, weight : 30 Kgs, Load bearing capacity : 5000 Kgs

Supply and Installation of 120Watt Booster Amplifier, the amplifier is protected against overload and short circuits. A temperature-controlled fan ensures high reliability at high output levels and low acoustic noise at lower output levels. An overheat protection circuit switches off the power stage and activates an LED on the front panel, if the internal temperature reaches acritical limit due to poor ventilation or overload of make: Bosch/ Honeywell.

Supply and Installation of Wall mounted 30W Cabinet Loudspeaker, High-fidelity music and speech reproduction, Selectable 8 ohm, 70 V and 100 V inputs, Compact yet robust ABS enclosure, Supplied with adjustable mounting bracket, Complies with international installation and safety regulations of make: Bosch/ Honeywell.

Supply and fixing of wireless hand held microphone Having Frequency Response of 40Hz-13kHz etc., complete of make : Ahuja/Mega/Studio Master