Loading…
Loading…
Tender Value
₹1.2 Cr
EMD Value
₹2.3 L
Closing Date
8 Jul 2026, 4:00 pm
Similar tender results from the same govt authority in the past 3 years.
Executive Engineer PW hyd div Zanskar
Executive EngineerPwhyd div Zanskar
Design Supply and Installation of Solar Submersible Pump Sets with all accessories i e SOLAR PV MODULES PUMP MODOUL PUMP MOTOR including Providing and Laying of Raising mains of HDPE Pipe of 125mm dia for Stage Ist and 2nd Solar Lift Irrigation Sche
2026_PWD_19108_1
e-tender 10 of PWHyd div Zanskar 2026-27
Open Tender
Civil Works - Others
180 days
Padum Zanskar
Please refer Tender documents.
3 documents required · 3 mandatory
₹1,500
Yes
Payable To Executive Engineer Pw hyd div zanskar
₹2.3 L
Yes
24 Jun 2026
24 Jun 2026
10 Jul 2026
24 Jun 2026
8 Jul 2026
24 Jun 2026
This is a percentage-rate BOQ. The schedule below shows estimated quantities and rates. Bidders quote a single percentage above or below the total estimated cost.
| Sl No | Description | Qty | Unit | Est. Rate | Est. Amount |
|---|---|---|---|---|---|
| 1 | Supply and installation of solar submersible pump set in tube well/stream/river for clear and cold fresh water as per IS8034 of 1989 with latest amendment. The control panel shall be designed for operation of both solar and grid supply. The control panel shall be completed with inherently under voltage and over load protection. The complete job including all civil and mechanical work and all short of carriage to make system functional as per the direction of site Engineer.
AC/DC solar Submersible pump permanent magnet mortar with 92% efficiency & Combined efficiency not less than 67%. The controller must have 1P54 protection with RMS system with live real time GEO location and should be able to send pump data to the cloud.
The PV module should be bifacial mona perc 454Wpas per MNRE guidelines.
Multistage Pump of minimum 22 stages.
Pump should be of SS 304 made with impeller also as per AISI 304.
Pump Speed should not be less than 3000 RPM and shall be suitable for permissible sand content.
Curve Tolerance: ISO 9906: 201233.
: The Motor should have 92% Efficiency and should be fully SS with quality certification of EN 14301, AISI 304.
1.The control panel shall be fully automatic push button operated for motor. (One complete Job). The controller shall be as per IP54 protection with Live GEO tagging and pump data to be shared on cloud in from secured data. 1. Maximum Power Point Tracker (MPPT) shall be included to optimally use of power available from the SPV array and maximize the water discharge.
2. The SPV Controller must be IP 54 Protection or shall be housed in a cabinet having at least IP Protection & have a Angle iron shed of Size (6'x6'x7') of MS sheet of 3mm thick welded on angle iron Size 40x40x4 mm including priming & painting ,also embeded in the ground complete job.
3. Adequate Protections shall be provided in the SPV Controller to protect the Solar Powered Pump set against the following:
Dry running
Open Circuit
Accidental output short circuit
Under voltage
Reverse polarity
SPD to arrest high current surge
A good reliable DC Circuit Breaker as per IS/IEC 60947-2 suitable for switching DC Power ON and OFF shall be provided in the SPV Controller
All Cables should be as per IS 694. | 1 | Nos | 36,00,000 | ₹36,00,000 |
| 2 | Capacity of pump in LPM-600LPM. Dynamic Head of the pump-50 mtr. Capacity of Mortor-15 HP. | 1 | Nos | 11,25,000 | ₹11,25,000 |
| 3 | Excavating trenches of required width for pipes, cables, etc including excavation for sockets, and dressing of sides, ramming of bottoms, depthupto1.5m, including getting out the excavated soil, and then returning the soil as required, in layers not exceeding 20cm in depth, including consolidating each deposited layer by ramming, watering, etc. and disposing of surplus excavated soil as directed, within a lead of 50 m: All kinds of soil Pipes, cables etc, exceeding 80 mm dia.
Total length of Raising mains 1600+570=2170.00meter. | 2,170 | Rm | 606.72 | ₹13,16,582.4 |
| 4 | Supply and fitting of high-density polyethylene pipe (HDPE pipe) material grade PN-16PE-100 confining to IS-4984/95 read with up-to-date latest amendments for the year 2020-21 including all necessary fitting items like nuts bolts washers etc as per the direction of site engineer and all carriage complete.125mm dia ODPN-16 PE 100 of 6-meter length and above HDPE pipe. | 2,170 | Rm | 2,300 | ₹49,91,000 |
| 5 | Supply and fixing of solar submersible cable of 3 core copper of 16 Sqmm to 26 Sqmm make finolex or any other univalent brand. | 150 | Rm | 1,250 | ₹1,87,500 |
| 6 | Supply and fixing of Steel safety Wire горе IS-12735. | 100 | Rm | 250 | ₹25,000 |
| 7 | Supply and fixing of MS flange Pipe of 200 dia of 6m length including trench excavation, refilling the excavated earth after laying of pipes, making the surface good by laying cement concrete. | 3 | Nos | 35,000 | ₹1,05,000 |
| 8 | Operation and maintenance of Solar lift irrigations scheme for a period of 3 year after completion of the schemes. | 1 | Nos | 2,50,000 | ₹2,50,000 |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Tendernotice_1.pdf
PDF • 1.00 MB
BOQ_45565.xls
BOQ • 0.25 MB
Download all tender documents and submit your bid