Fabrication Tenders in Jharkhand

Fabrication and erection of 7 no. feeder rail line by changing/modification of hanger system lifting of crusher chute to the normal position and fixing it by the support of 200 mm beams at Kathara Washery

Fabrication bell crank and mountings engine trans guards hyd guards both side arm and pins both side ladders engine hood mountings opt cabin glass etc of WA800 and WD20 Dozer of Ashok OCP of Piparwar Area.

Dismantling of motor gear set with base plate, fabrication of new gear motor base along with providing and fixing of coupling and alignment of TB-1 motor gear box set installed under Churi Colliery, NK Area

Repairing of Drilling Platform and its Rubber Guard fitting, Dust Collector Housing, Track Frame both side, Fabrication and Fitting of both sides Idler Guard of IDM-30 Drill, Sl. No.- 667 (DR-200) of AMP colliery.

FABRICATION OF NEW SECOND MOTION SHAFT OF 75 HP HAULAGE AND DISMANTLAING OF SECOND MOTION DUAL PINON FROM BROKEN SHAFT, REPAIRING OF PINION TEETH, BLOCK BORE MACHINING, LIFTING OF HAULAGE IN 7 LEEL AND FITTING COMPLETE

Moulding, casting, fabrication and lathe work of pin bus type rigid coupling and tyre coupling with finished bore and arrangement of pulley for coupling of compressor and motor for Sykes pump under Ashok OCP, PPR Area.

Fabrication / Erection of BC-2 tail drum, H/D protective shield for rotating equipment and railing along the floor nearby BC-2 conveyor to prevent any near miss or accident at Deshaling Plant of Sawang Washery.

Complete repairing of 02 nos. bend drum and snub drum dia (654X1400mm) unit no. 133AandB belt conveyor and repairing or fabrication of 02 nos. tail drum pulley dia 550X1800mm 112AandB of Pre Washery at Kedla Washery.

Replacement of wornout deck plates, fabrication and erection of new deck plates and dismantling, installation and erection of brackets with rollers of Unit no. 401 Tailend side at Madhuban Coal Washery under Block-II Area, BCCL.

Execution of Miscellaneous Electrical and Safety Works near Kargali Siding like Fabrication and erection of lighting tower for improved illumination in the loading area, Installation of ESE-type lightning arrestor, Stringing of sagging spans of HT

a)Repairing / Fabrication of end bit (04 nos.), cutting edge (08 nos.) applicable for D155 dozer as float, (b) Repairing of 07 nos. operator seat and operator seat mountings for Dozers at Ashok OCP, Piparwar Area.

Replacement of worout intermediate frame and deck plates installation of idler frame with rollers fabrication and erection of same of unit no 903 of PS 9 section at Madhuban Coal Washery under Block II Area BCCL

Fabrication / Erection and repairing different washed coal and washed coal power receiving chute replacement / repairing of shuttle conveyor middling and clean coal receiving chute mother plate and liner plate, repairing of different railing at CCB S

Dismantling , repairing and backfitment of 02 nos. rear suspension assy, seal replacement , bush fitment and pin fabrication, repairing and backfitment of stair, mud flap guard, safety walk, stopper frame, engine - transmission guard, etc of BH60 T73

Dismantling at Old Raw Coal weighbridge and Fabrication Erection at new Raw Coal weighbridge of C.G.I Sheet made shade along with preparation of Landing plate form of dumper operator along new weighbridge at Moonidih Coal Washery.

Repairing, overhauling and fabrication / Erection of steel structural work cable tray structure, support etc. of 40 BC, Vibration both side 01 to 06 no. and BC4A, 42 Screen etc. work in Electric Section at Sawang Washery.

Dismantling of buckets, liner plate etc. and fabrication/erection of steel structural work, and installation of bucket elevator with feed launder box liner plates change, bucket drive patti etc. work in Deshaling Plant at Sawang Washery.

COMPLETE PAINTING WORK OF (INNER AND OUTER) SIDE OF MS SHEET OF NEW EMPLOYEE STAND ROOM AND PAINTING WORK FOR NEW FABRICATION OF SHED IN ELECTRICITY ROOM AT SIJUA SIDING CHP AT AAWS UNDER KATRAS AREA

Dismantling, fabrication, erection and alignment of belt structure of 512 and 549 belts and discharge chute liners of 513 belt and other related jobs as per requirement under PS-5 Main Washing Plant of Rajrappa Washery.

Dismantling of head drum of unit no. 180 B/C and 181 B/C then repairing, fabrication, erection and installation of the same including repairing of its supporting structure in Raw Coal Section of Kathara Washery

(A) Repair/ Fabrication of 02 Nos. crowd motor pinion assembly of M/C Exc-1851 and EKG-2859 Shovel (B) Repairing of (RHS) Swing gear box assembly for BE-195 Exc-1075 Shovel of Kathara Coliery.

Fabrication of teeth type metal wear resistant picks and fixing in secondary crusher roller of BWF make feeder breaker installed at Tarmi siding of SDOCM project in order to achieve maximum efficiency in crushed coal size.

1. Repairing of carrier roller and fabrication of propel motor guard etc work of Tata Hitachi Sl. No. - 182. 2. Repairing /cleaning of radiator assly. of Tata Hitachi Sl. No.-182 and L and T-768.

Painting of poles near WB No. 01 area, stringing of LT OH line conductor, fabrication and installation of cradle guard and fencing of mini sub-station near WB No. 01 in Ashok OCP under Piparwar Area.

Providing, installation sluice valve, non-return valve, coupling set and fabrication of base platform for pump motor set going to be installed at river side of konar railway siding in respect of AKK OCP, BNK Area

fabrication of different size pipe - pole, erection the same pipe - pole, erection of chemical earth pit, installation of franklin rod and sky wire erection at nine nos. road and one no rail weighbridges under Kusunda Area

Fabrication and Supply of the Ducts, Duct supports and Enclosure support structures as per the approved detailed drawings (Procurement of Raw Material including Steel is in the scope of Bidder) for 3x800 MW PVUNL Project Patratu

Dismantling, repairing, backfitment radiator assy and its foundation, power lift cylinder, drawbar side shift cylinder, Repair/fabrication of gate lock, engine hood, mounting, guard, transmission guard, LHS RHS side panel, etc of BG825 G5 at AOCP

INSTALLATION OF 150 HP PUMP - MOTOR SET WITH ELECTRICALS, DELIVERY RANGE 6 DIA SQUARE PIPE APPROX 500 MTR FLOW PUMP TO UPPER BENCH AND FABRICATION OF SHED AT PUMP STATION IN PATCH B OF GOPALICHAK COLLIERY.

Repairing/ Fabrication and Erection of 241 dilute media tank reducer at suction point and bends in delivery line with provision of newly fabricated of flanges and packing up to 9mtr. at H.M.S Section at Kathara Washery

fabrication of iron material and making power distribution panel size 3ft x 2ft with supply and installation of all accessories MCCB, indicator, Ampere and volt meter, frequency meter, Bus bar etc. at Area office Kusunda Area

DISMANTLING AND RE ERECTION OF OLD 10INCH BHUMI DELIVERY FROM AMBEY GOLAI TO 40 NO. COAL DUMP AND THERE ROAD CROSSING FABRICATION AT AMBEY GOLAI AND 40 NO. COAL DUMP AT AKWMC OCP UNDER KATRAS AREA

Replacement of worn out intermediate frame deck plates installation of idler frame with rollers fabrication and erection of same at 902 belt conveyor at PS 9 Building at Madhuban Coal Washery under Block II Area BCCL

FABRICATION OF 80 PIPES, 10inch DIA MS FLANGE 160 NOS. and 50 PIPE 8inch DIA M.S. FLANGE 100 NOS. and 70 PIPES, 6inchDIA MS FLANGE 140 NOS BY FLANGE FITTING IN BOTH SIDE AT CHP PREMISES

Fabrication of 115 no hard metal picks including hard facing and fixing on secondary drum roll of BWF make feeder breaker no 2 installed at JRD RLY siding in respect of Konar Exp under BnK Area

Repair of Compressor Tank, Battery Box, Lock System, Telescopic Cylinder, Blade with Electrodes Filling, Fire Extinguisher Holder, Ladder and Cabin, New Glass Fitting, Bonnet Cabinet, Control Lever and Light Box, Diesel Tank cap Fabrication of MG3134

Fabrication and installation of HDPE floating pontoon of size 60 sq mtr for installation of 01 no 1000 GPM pump at 3p sump in r/o SDOCM Project of Dhori Area against approved monsoon activity 2025

Providing and fixing of starter in operating machine at different section, overload relay, power contactors with required accessories in EOT Crane of machine shop and STR Shop. Repairing, maintenance and fabrication of metallic structure and installa

Old and major damaged boom cylinder new fabrication by repairing of barrel, piston, check nut new making with new seal kit fitting of ZX650H Tata Hitachi shovel, Exc-2912 of Govindpur Ph-II OCP, Kathara Area

3rd shifting of 02 nos. 1000 GPM Pump, Fabrication of section accessories of three nos pump at departmental sump and laying of 8 inch / 4 inch pipe line for fir fighting of Kabribad Mine, GRD Project.

Fabrication of aluminum glass frame and new safety glasses fitting in cabin and straightening of cabin door and new safety glass fitting in door of IDM30 drill Sl. No. 833 at Tetulmari OCP of Sijua Area.

Repairing of Transformer Room with Fabrication of One Door by supply and fitting of New Galvanized Sheet for Safety of 800A ACB Switch and 500 KVA 11 KV/440V Transformer Near Central Workshop for Bastacolla Colliery.

Repairing of Boom eyes, bucket eyes, boom housing, arm housing, rear axle trunnion alongwith fabrication and pressing of bushes of bucket, boom foot and arm of CAT988H Payloader Sl. No. A7A00282 (FEL 330) of Religara Project.

Repairing 01 no CAC assy 02 nos. rear suspension, seal replacement , pin fabrication of 01 no. panhard 01 no. radiator assy and bracket mounting etc for BH60M Dumper T69 of Ashok OCP of Ashok OCP.Refer NIT

Dismantling of hoisting pin replacement, eye rebuilding and seal replacement of both housing system, repair and back fitment of 02 no steering cylinder (seal replacement, eye fabrication, bush fitment), etc of CAT777D Dumper TH11 at AOCP

Repairing / Fabrication of Water Sprinkler for Water spraying arrangement and Repairing of operator cabin platform, operator seat, new safety glass, rubber fit , lock realing of WS28KL Water Sprinkler SL.No. 28208 of Kuya OCP, Bastacolla Area IX.

New making fabrication for Operator Cabin in RH/side and LH/side to prevent rain water in the top of the window in 182 M Marion Shovel Sl. No. Exc-1851 and 1844 at Kathara Colliery.

Fabrication and Erection of stair going to C-1 head side and NS-1 and NS-2 Screen modification of receiving chute, side skirt, gallery support structure of C-2 belt conveyor at Moonidih Coal Washery.

Dismantling of old damaged and Fabrication / Erection, alignment of new skirt rubber, skirt guard frame of ROM B/C, Picking B/C, Reversible B/C and A side shuttle conveyor in PCH Section at Sawang Washery.

Design, Manufacture/ Fabrication, Testing, Assembly, Inspection, Supply of Multistage Centrifugal Pump with motor for HPALA Service and Booster pump with motor for Mechanical sealing of HPALA Pump on FOR Site basis and Supervision during erection and