Industrial Machinery Tenders in Andhra Pradesh

TENDER DOCUMENT FOR SUPPLY, INSTALLATION, TESTING, COMMISSIONING AND TRAIL RUN OF MACHINERY AND EQUIPMENT FOR SRI SATYADEVA PRINTING CLUSTER ASSOCIATION - KAKINADA (SPV) Plot No.197, Sy. No. 67, APIIC, Ramanayyapeta, Kakinada - 533001

2026-HOR01-CB-104-Taskforce for Engaging one no. of 5.50 Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in GAJUWAKA ZONE including all machinery & Crew etc.,

2026-HOR01-CB-348- Taskforce for Engaging one no. of 5.50 Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in GAJUWAKA ZONE including all machinery & Crew etc

Providing weed and jungle removal by manual and machinery on YLM Canal, Link canal from KM 0.00 to Km 5.00, Water supply canal from km 25.00 to KM 33.60 in Reach-III

Providing Machinery to carryout removal of out crop and for closing of syphon points from Km 248/000 to Km 250/580 & TS, 1L, 3L & 73 DP in Hanwal Section of RBLLC.

Gudur Municipality - Navarathnalu - Pedalandariki ILLU - Jungle Clearance cutting the heaps and filling of dips by machinery levelling the site and formation of roads with Gravel at Survey No.2055 of west Gudur

Annual repairs & maintenance of 17 Nos of all types of light & heavy PH section sanitation vehicles and earth mover machinery working in Zone-I of GVMC for a period of 12 months

2025-HOR01-CB-169- Taskforce for Engaging one no. of 6Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in Zone-II (Madurawada) including all machinery & Crew etc.,

Laying of 1100mm dia balance MS Pipeline between MD Puttur to Mangalam Pumping STation inclduing enchancement of Pumping machinery along with connected components like pump sets, transformer etc., in Tirupati Municipal Corporation.

2025-HOR01-CB-166- Taskforce for Engaging one no. of 6Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in Zone-VI (GAJUWAKHA ) including all machinery & Crew etc.,

Providing / Filling of C & D waste and Murrum / Good Gravel to large size trenches by engaging hire machinery and tippers trucks, in Survey No 322-C at S.S Tank in Guntakal Municipality

2025-HOR01-CB-167- Taskforce for Engaging one no. of 6Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in Zone-IV (SURYABAGH ) including all machinery & Crew etc.,

2025-HOR01-CB-165- Taskforce for Engaging one no. of 6Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in Zone-III (Asilmetta ) including all machinery & Crew etc.,

2026-HOR01-CB-349- Taskforce for Engaging one no. of 5.50Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in ANAKAPALLI & AGANAMPUDI ZONE including all machinery & Crew etc.,

2025-HOR01-CB-168- Taskforce for Engaging one no. of 6Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in Zone-V (Gnanapuram) including all machinery & Crew etc.,

2025-HOR01-CB-169- Taskforce for Engaging one no. of 6Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in Zone-II (Madurawada) including all machinery & Crew etc.,

2026-HOR01-CB-105-Taskforce for Engaging one no. of 5.50Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in ANAKAPALLI & AGANAMPUDI ZONE including all machinery & Crew etc.,

Suction and delivery valve assembly of M/s. Kirloskar make compressor of MEMU type 3 HC.55 comprising of: (1) 0910138550 - suction valve assembly - 3 Nos. (2) 0910138650 - Delivery valve assembly - 3 Nos.Make/Brand: KIRLOSKAR.

HERMETICALLY SEALED SCROLL COMPRESSOR , SUITABLE FOR R-22 GAS, OPERATING VOLTAGE 380/420 VOLTS AC,3 PHASE,50 HZ, to Emersion climate MODEL NO.ZR-61 KC-TFD-522 or equivalent with prior approval of RDS

M4801164756_Vindhyachal, M4801164563_Vindhyachal, M4801164925_Vindhyachal, M4801164756_Simhadri, M4801825357_Simhadri

Replacement of Worn out Grinding rolls, Bull ring segments, Vane wheel assembly, Bull ring clamping ring, Bowl extension ring & other connected mill internals and other repair works for Mill-1C of Unit-I Boiler including T&P and consumables

Overhaul works on Boiler pressure parts for replacement of eroded water wall, DNPSH, Platen SH tubes, carrying out cracked fin welding where ever required during D meter survey at Unit-7/ Stage-IV during annual overhaul period 2018-19.

Certain maintenance works Break down works and repair works for ESP of Unit I i.e EERM CERM and GD rapping gear boxes shaft bearings and drives as and when required during the year 2020 21 for unit I Boiler

Replacement of Worn out Grinding rolls, Bull ring segments, Vane wheel assembly, Bull ring clamping ring, Bowl extension ring & other connected mill internals and other repair works for Mill-1E of Unit-I Boiler during the year 2025-26

Replacement of Worn out Grinding rolls, Bull ring segments, Vane wheel assembly, Bull ring clamping ring, Bowl extension ring & other connected mill internals and other repair works for Mill-1C of Unit- 1 Boiler including T&P and consumable

Replacement of Worn out Grinding rolls, Bull ring segments, Vane wheel assembly, Bull ring clamping ring, Bowl extension ring & other connected mill internals and other repair works for Mill-2D of Unit-II Boiler including T&P and consumables.

Replacement of Worn out Grinding rolls Bull ring segments Vane wheel assembly, Bull ring clamping ring, Bowl extension ring & other connected mill internals and other repair works for Mill-2A of Unit-2 Boiler including T P and consumables

Replacement of Worn out Grinding rolls, Bull ring segments, Vane wheel assembly, Bull ring clamping ring, Bowl extension ring & other connected mill internals and other repair works for Mill-2E of Unit-II Boiler including T&P and consumables

Repairs of secondary air duct (APH out let to wind box inlet) & Flue gas duct (Economizer outlet to APH, ESP outlet to Chimney area) at the boiler of Unit- II during the running and annual overhaul period 2022-23

Replacement of Cold end Sector plates (Primary air to Flue gas side) (1 no per each APH) on Air preheaters 7A and 7B in unit 7 Boiler during the Annual overhaul/ Capital overhaul period in the year 2024-25

Procurement of Spares for BFP Booster pump coupling MDBFP and TDBFP forTG and Auxiliaries NTPC Lara Stage I 800 MW Units FLEXIBLE COUPLING OFTDBFP OF NTPC RIHANDBetween Turbine and Gear Box

Improvement to Eluru & Ryves canals by taking up repairs such as overhauling of Gear box, shutter painting, safety arrangements and other works to the locks & Regulator in Town works section, vijayawada

Annual maintenance of pressure parts of Unit-3 and 4 Boilers from the date of awarding work to 30.09.2026.

OIL LEVEL SENSOR SNO K516218.4, HP SWITCH RANGE 8 to 32 BAR, 100 to 465 PSIG, LP SWITCH MAKE DANFOSS, DIFFERENTIAL OIL PRESSURE CONTROL SWITCH, TYPE MP, VOLTAGE MONITORING RELAY, SN 255170, FUSE 10 A CARTRIDGE, AUTO DRAIN VALVES SVASSY1 by 2 BSP36KSC, MARINE CONTROL UNIT, MODEL ID MDU, VP MARINE 1.6.1, FUEL LEAKAGE SENSOR, MODEL D7A BTA, CMOS BATTERIES, CR2450N 3V LITHIUM CELL, TANK SENSORS FUEL TANKS, DIRTY WATER TANK SENSORS, KFG LEVEL AGCH 6341 BOAR, COOPER BEARING SENSOR, TEMPERATURE SENSOR, 01 BCP130MM, AIR TEMPERATURE SENSOR, RANGE -5 TO 35 DEGREE CELCUIS, SHAFT LOCKING DEVICE, LUB OIL FLOW SENSOR B112, POWER PACK, TEMPERATURE SENSOR, TYPE 1XPT 100, SHAFT FLOW METERS, TYPE UQS, SEA WATER TEMPERATURE GAUGES FOR CONDENSOR, HIGH PRESSURE SWITCH, MODEL KP 5 RESET TYPE, LOW PRESSURE SWITCH, MODEL KP 1, OIL PRESSURE SWITCH, MODEL MP 55, DIFFERENTIAL PRESSURE SWITCH, MODEL RT 262 A, SEA WATER TEMPERATURE GAUGES, RANGE -1.0 TO 1.0, THERMOMETER OF SYSTEM LINES, RANGE 0 TO 60 DEG CELSIUS, DIMENSION 150 X 36 MM, SOLENOID VALVES, 50 to 60 HZ, 10 W, 220-230 V, SOLENOID VALVE, 3 by 2 NO, MODEL C321, MAXIMUM PRESSURE 35 BAR, DISCHARGE AIR TEMPERATURE GAUGE 0 TO 200 DEG CELSIUS, FIRST STAGE AIR PRESSURE GAUGE 0 TO 6 BAR, PRESSURE GAUGE, SUCTION PRESSURE GAUGE, -1 TO 9 BAR, DISCHARGE PRESSURE GAUGE 0 TO 8 BAR, PRESSURE GAUGE, SUCTION PRESSURE GAUGE -1 TO 1.5 BAR, DISCHARGE PRESSURE GAUGE 0 TO 8 BAR, PRESSURE GAUGE, SUCTION PRESSURE GAUGE -1 TO 1 BAR, DISCHARGE PRESSURE GAUGE 0 TO 10.6 BAR, TEMPERATURE SENSOR, PRESSURE SENSOR, RPM SENSOR, THERMOMETER 0 to 100 DEG, ON SUCTION and DISCHARGE OF CONDENSER, WATER FLOW SWTICH, TYPE KP 2 Bid Details 2/32

Repairs and Maintenance of Electrical Cranes, Mobile Equipment, other Plants, Machinery and Equipment etc. and Manning and Operation of various facilities and installations located in Shipbuilding (SB) Yard and Ship Repair (SR) Complex

Providing Machinery to carry out miscellaneous works such as filling rain cuts, Gullis, Scouredportions and siphon portions, free board repairs and clearing catch water drains in deepcut reaches in Hanwal Section of RBLLC.

2024-HOR01-CB- 123- Task force- Proposals for duly engage of one tipper for tree branches pruning , lifting of tree waste including all machinery and crew for 300 days in zone- III ( Asilmetta)

2024-HOR01-CB-120- Task force- Proposals for duly engage of one tipper for tree branches pruning , lifting of tree waste including all machinery and crew for 300 days in zone- 5 ( Gnanapuram)

Gudur Municipality - Navarathnalu - Pedalandariki ILLU - Jungle Clearance cutting the heaps and filling of dips by machinery levelling the site and formation of roads with Gravel at Survey No.2035 & 2034 of west Gudur

Providing Machinery to carry out miscellaneous works such as filling rain cuts, Gullis, Scouredportions and siphon portions, free board repairs and clearing catch water drains in deepcut reaches in Basapuram Section of RBLLC.

2024-HOR01-CB- 123- Task force- Proposals for duly engage of one tipper for tree branches pruning , lifting of tree waste including all machinery and crew for 300 days in zone- III ( Asilmetta)

2024-HOR01-CB- 123- Task force- Proposals for duly engage of one tipper for tree branches pruning , lifting of tree waste including all machinery and crew for 300 days in zone- III ( Asilmetta)

2024-HOR01-CB-119- Task force- Proposals for duly engage of one tipper for tree branches pruning , lifting of tree waste including all machinery and crew for 300 days in zone-4 (suryabagh )

2024-HOR01-CB-120- Task force- Proposals for duly engage of one tipper for tree branches pruning , lifting of tree waste including all machinery and crew for 300 days in zone- 5 ( Gnanapuram)

2024-HOR01-CB- 122 - Task force- Proposals for duly engage of one tipper for tree branches pruning , lifting of tree waste including all machinery and crew for 300 days in zone-II (Madurawada )

2024-HOR01-CB- 122 - Task force- Proposals for duly engage of one tipper for tree branches pruning , lifting of tree waste including all machinery and crew for 300 days in zone-II (Madurawada )

2024-HOR01-CB- 123- Task force- Proposals for duly engage of one tipper for tree branches pruning , lifting of tree waste including all machinery and crew for 300 days in zone- III ( Asilmetta)

2025-HOR01-CB-345- Taskforce for Engaging one no. of 5.50 Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in EAST ZONE (Asilmetta) including all machinery & Crew etc..

2026-HOR01-CB-102- Taskforce for Engaging one no. of 5.50 cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in SOUTH ZONE (SURYABAGH) including all machinery & Crew etc.

2026-HOR01-CB-101-Taskforce for Engaging one no. of 5.50 Cmt. Tipper on hire basis for tree branches pruning, lifting the tree waste in EAST ZONE (Asilmetta) including all machinery & Crew etc.,