Inspection, Testing & Audit Tenders in Uttar Pradesh

Custom Bid for Services - Total Lumpsum Charges including GST for Calibration of pocket dosimeter as per tender terms and condition for

HEX HEAD CAP SCREW SIZE 3/4"-10 TPI X 2-1/2" LENGTH TO DLW PT.NO. 15010193 S.NO.70 OF DLW DRG.NO. TPE-13-0044 ALT.-t or latest up to tender opening FROM DLW APPROVED SOURCE ONLY.

ANNUAL RATE CONTRACT FOR SUPPLY, CALIBRATION AND TESTING OF MULTIFUNCTION GAS DETECTORS, MERCAPTAN DETECTOR (TBM/ETHYL MERCAPTAN), LEL DETECTOR and GAS DETECTOR (LEAK SURVEYOR) FOR IOAGPL ALL ASSETS

Custom Bid for Services - 9050C26A22 : Agency for Calibration of Measuring/Testing Equipment in Mathura Refinery, QC Lab for three years Similar Category Repair, Maintenance and Installation of Plant Systems/Equipments

Procurement of refilling of gases (SO2, CO2,CO,NO,N2) for CEMS and CAAQMS system, O2 gas for boiler and FGD area of 1x660MW ETPS and Calibration Gas Cylinder for Analyzers against O and M Head CTPS and DTPS and Calibration gas H2 and CO2 for H2 pur

Custom Bid for Services - Calibration of Master Mass flow meters MFMs of sizes 4 inch 6 inch and 8 inch available at various locations in UP state through FCRI Lab Palakkad and Stamping from dept of Legal metrology Weights and Measure Govt of UP ... Category Calibration Services

Periodic Testing/ Hydro-Testing and Painting of 1X 1400 MT Horton Sphere, Periodic Testing/ NDT of 1X900 MT Mounded Storage Vessel and Supply and installation of fire safe Remote Operated Valve at LPG bottling Plant, Pattikalan

Non-Destructive Test NDT and Residual Life Assessment RLA of various RCC and steel structures at i Mathura Refinery Plant ii Mathura Refinery Township iii Koyla Intake Pump House, Mathura iv Keetham Intake Pump House, Agra

Flaw check cleaner/Remover to RDSO Specn. M&C/NDT/105/2001 Solvent Remover-Class 2-Non-Halogenated in Aerosol container 500ml capacity with net content of 400ml -3 Nos, Flaw check developer to RDSO Sp

SET OF ITEMS CONSISTING OF: 1) PREMIXED BLACK MAGNETIC PARTICLE AS PER, RDSO/M&C/NDT/109/2007, REV2 (OCTOBER 2020) (WET METHOD) IN OIL MEDIA IN A 500 ML DISPENSER OPERATING AEROSOL CONTAINER (NET CONT

Flaw check cleaner/Remover to RDSO Specn. No. M&C/NDT/105/2001 Solvent Remover- Class 2- Non Halogenated in Aerosol container 500ml capacity with net content of 400ml -3 Nos, Flaw check developer to R

Calibration Services - For measuring TDS and Conductivity of distilled water; TDS METER AND CONDUCTIVITY METER; NABL Labs, Any other Government Approved Labs/Service Provider; Buyer premises (onsite)

Repair and Overhauling Service - Multifunction Machines MFM; Polarimeter Display Repair with Calibration; Yes; Service Provider Premises, Repair and Overhauling Service - Multifunction Machines MFM; UPS Repair; Yes; Service Provider Premises

Design, procedure development, supply procurement, replacement of top crown with nozzles and top polar petals, maintenance, piping, NDT, testing, inspection, PESO approval, fire-proofing, painting works for 2 nos. of 1500 M3 LPG Horton Spheres at MR

CO2 GAS CARTRIDGE FOR DRY CHEMICAL FIRE EXTINGUISHERS OF 5 KG. CAPACITY. SIZE: 46 MM X 230 MM X 6 MM. TOTAL LENGTH OF THREADED PORTION WITH LEFT HANDED THREADES (20 TPI) SHOULD BE 10.5 MM AS PER IS: 4

BIMETAL BAND SAW BLADE ENDLESS, SIZE- 34 MM X 1.1 MM x4860 MM x 4 TPI WITH REGULAR TOOTH SHAPE & RAKER TYPE OF SET, M-42 GRADE, TYPE-E, IS:4875/1978, PART-I,II,III. MAKE- STARRETT, AMADA, BAHCO (SNAP-

flannellette rolls of cm width Flannellette Rolls Of Cm Width ( 1100 ) Technical Specifications * As per GeM Category Specification Specification Specification Name Values Allowed Values SPECIFICATION Governing Specification Confirming to IND/TC/0150 ... of Quality Assurance , ...

Customized AMC/CMC for Pre-owned Products - AMC AND CALIBRATION OF BAIRD DIRECT READING SPECTROMETER; BAIRD; Annual Maintenance Contract (AMC); Quarterly; No

HIRING OF AGENCY FOR CALIBRATION OF RPD/TFM METERS AT SONIPAT, MEERUT, DEWAS, MANDIDEEP, MUGHALSARAI, ADITYAPUR, ROURKELA, DEHRADUN, PURI AND DHANBAD GAs

Overhauling, Calibration, Testing , commissioning of Manometry Instruments including Repairing of damaged LIE, LIR and Junction Boxes etc of unit 11 3X200MW BTPS

Calibration Services - PAMAS S 40; AS PER ISO 4402 USING ISO ACFTG SUSPENSION IN MILH; AS PER OEM MANUAL; Buyer premises (onsite)

REPAIR /REPLACEMENT WORKS TO ELECTRIC INSTALLATIONS, EARTHINGS, CALIBRATION OF RELAYS, LT UG CABLES, LIGHTS AND CONNECTED WORKS AT TKD UNDER GE BABINA

Custom Bid for Services - CALIBRATION OF AIR DATA TEST SET ADTS MPS 27C at HAL Korwa Amethi UP against SPR No 21SPR126()

DGA Calibration Gas mixture (Standard gas) in 500ml cylinder aluminium can contain 10 litres of available gas at pressure 20 kg/cm2

DIGITAL VERNIER CALIPER , SIZE- O-300 MM,L.C.-0.O1 MM, WITH CALIBRATION CERTIFICATE(NABL CERTIFIED LAB),MAKE- MITUTOYO /INSIZE OR SIMILAR

Hand Operated Metal Body Insulation Tester 1000 Volt, 2000 Mohm, Make - Waco or Similar. Calibration Certificate is required from NABL approved lab.

Calibration Services - As per Scope of work; As per Scope of work; As per Scope of work; As per Scope of work

Calibration Services - As mentioned in Tender Bid document; As mentioned in Tender Bid document; NABL Labs; As mentioned in Tender Bid document

Calibration Services - As per the bid document; As per the bid document; As per the bid document; As per the bid document

Custom Bid for Services - CALIBRATION OF EMD STANDARD LAB EQUIPMENTS OF NTPC AURAIYA Similar Category Operation and Maintenance Power House/Power Plant

HIRING OF SERVICES FOR WELL TESTING IN BLOCK CB-ONHP-2017/12

Design/ procedure development, supply/procurement, replacement of top crown with nozzles, maintenance, piping, NDT, testing, inspection, PESO approval, fire-proofing, painting works for three (3) nos. of 1500 M3 LPG Horton Spheres at MR on LSTK basis

Set of MPT Kit consisting of two items. (i) Premixed black magnetic particle as per RDSO/M &C /NDT/109/2007 (Rev-2) OCT-2020 (Wet method) in oil media in 500 ml dispenser operating aerosol /containe

Custom Bid for Services - Statutory Hydrotesting, NDT Testing, Certification and Calibration of MSV (1 X 600 Mt) at Lucknow LPG Plant Similar Category Testing Service for On-Board/Commissioned Equipment/Instrument related to Plant

Custom Bid for Services - STATUTORY HYDROTESTING, NDT TESTING, CERTIFICATION AND CALIBRATION OF MSV (1 X 600 MT) AT SALEMPUR LPG PLANT Similar Category Testing Service for On-Board/Commissioned Equipment/Instrument related to Plant

Custom Bid for Services - Item1 Calibration & Testing of Instruments Pressure Gauge for detailed scope of work refer tender document and Bidder shall quote amount inclusive of GST for total quantity of 4725 in 2 years contract period, Custom Bid for ... Item2 Calibration & ... Item3 Calibration & ... Item4 Calibration & ... Item5 Calibration & ... Item6 Calibration & ... Item7 Calibration & ... Item8 Calibration & ... Category Calibration Services ... Services Calibration Services ... Services Calibration Services ... Services Calibration Services ... Services Calibration Services ... Services Calibration Services ... Services Calibration Services ... Services Calibration Services

STATUTORY NDT INSPECTION CERTIFICATION HYDROTESTING 100 PERCENT REPLACEMENT OF STUDS AND GASKETS AND PAINTING OF 2X100 MT LPG BULLETS AT HALDWANI LPG BOTTLING PLANT AND 3X1200 MT LPG MOUNDED STORAGE VESSEL AT MATHURA LPG BOTTLING PLANT UNDER UPSOII

STATUTORY NDT INSPECTION, CERTIFICATION, HYDROTESTING AND PAINTING OF 3 X 150 MT AT LAKHIMPUR LPG BOTTLING PLANT AND 1 X100 MT LPG BULLETS AT HALDWANI LPG BOTTLING PLANTS AND 1X660 MT HORTON SPHERE AT FARRUKKABAD LPG BOTTLING PLANTS

STATUTORY NDT INSPECTION, CERTIFICATION, HYDROTESTING AND PAINTING OF 1X1400 MT LPG HORTON SPHEREAT LAKHIMPUR LPG BOTTLING PLANT 1 X1400 MT LPG HORTON SPHERE AT KASHIPUR LPG BOTTLING PLANTS AND 3X1550 MT MOUNDED STORAGE VESSEL AT LONI LPG BOTTLING

Non aqueous Developer (Spray type application), Form-D in Aerosol Cans of Capacity 500 ml, Net Content 400 ml, conforming to IS:12889/1989 and RDSO Spec No. M&C/NDT 105/2001 used in Dye Penetrant Test

:Black Magnetic Powder Oil Based for wet for crack detection by MPI Method in packing of 1 Kg or 500 grams as per RDSO Specification No. RDSO Specification No. RDSO/M&C/NDT/109/2007, (Rev-2), October

Dye Penetrate Test Kit to RDSO Spec. No. M&C/NDT/105/2001(One set consist of red eye penetrate 01 can, developer 02 can and cleaner 03 can) Accepted Make/Brand -Zenith spray WESAF Qty. 400 Set

REPAIR/RENEWAL/MAINTENANCE OF 33/11 KV INCLUDING CALIBRATION/TESTING 33/11 KV TRANSFORMER, HT SWITCH GEAR AND ALLIED WORK AT BABINA CANTT

Calibration Services - Mechanical; AMC FOR CM-20 EQPT WITH ACCESSORIES; Any other Government Approved Labs Service Provider; Hybrid (detailed in scope of work)

Calibration Services - ONLY REPAIR REQUIRED FOR PARTICLE COUNTER; ONLY REPAIR REQUIRED FOR PARTICLE COUNTER; ONLY REPAIR REQUIRED FOR PARTICLE COUNTER; Buyer premises (onsite)

REPAIR/MAINT OF 33 KV YARD AND POWER TRANSFORMER, CALIBRATION OF SWITCH GEAR AND PROTECTION SYSTEM AT CANTT ARA UNDER GE(I) KANPUR.

2025-26 (AMI No. 32.16) Cal 4 (Calibration solution f.BGA plus E/ high) Cat. No. 3-4.504, Pack size - 150 mL MAKE - ESHWEILER

Slip Gauge Set of 112 pieces, Grade k for steel with calibration certificate (NABL CERTIFIED LAB) Brand- Mikronix / Mitutoyo or similar Make: INSIZE

DIGITAL 3-LEG INSIDE MICROMETER SIZE-225-250 MM,L.C.-0.001 MM WITH CALIBRATION CERTIFICATE (NABL CERTIFIED LAB),MAKE-MITUTOYO/TESA OR SIMILAR

DIGITAL OUTSIDE MICROMETER, , SIZE-0-25mm, RESOULATION-0.001MM ,ACCURACY- 0.001mm, MATERIAL- STAINLESS STEEL WITH CALIBRATION CERTIFICATE(NABL CERTIFIED LAB),MAKE-MITUTOYO OR SIMILAR